Strymon Mobius Pedal Firmware 1.15
Dosya tipi: Firmware.
Işleti̇m Si̇stemi: AnyOS.
Dosya adı: mobius_firmware_1v15.zip.
Bit: 32/64 Bit.
Li̇sans: Ücretsiz.
Açıklama
What’s New:
– Added MultiSwitch EXP controller support with TAP, Bank, and Preset EXP modes.
– Added global to allow for turning off response to MIDI clock.
– Added default values for alt params for Destroyer
– Added support for bypass not touched during midi preset change.
– Added global for on/off midi send state on preset change.
– Added inverse remote Tap controller CC# 99.
– Improved MIDI Thru.
What’s Fixed:
– Resolved display issue with low frequency rotary.
– Resolved display issue with invalid characters and decimal points in a name.
– Resolved issue where if name is scrolling on display then global mode won’t be entered.
To check the firmware version on your TimeLine:
– Power up while holding down the TAP footswitch.
– Turn the TYPE encoder until REVISN is displayed.
– Push the TYPE encoder, and the firmware version will be displayed.
How to Update Your Pedal
Once your MIDI interface has been configured, you are now ready to update your Strymon pedal. Before proceeding with the following steps, make sure that your Strymon pedal is connected to your computer with a dedicated MIDI interface and that your Librarian software is open.
– Navigate to View > Software Update at the top of your window or screen.
– Click on “Install the Update”.
– After the update has successfully been installed, click “OK”.
– You can check in the bottom right corner of the Librarian to confirm the update was installed successfully.
İndirme