Klipsch HD Wireless Speakers Firmware 10.5.12
Dosya tipi: Firmware.
Işleti̇m Si̇stemi: AnyOS.
Dosya adı: hd-wireless-firmware-update-v10-5-12.zip.
Bit: 32/64 Bit.
Li̇sans: Ücretsiz.
Açıklama
SUMMARY OF UPDATES:
– Low-Volume Bass Boost added
– Power Save Mode added
– HDMI Standby Pass-Through added
– Smoother Setup Guide experience
– Bass management performance tweaks
– Enhanced update process
– Stability fixes
– Cosmetic improvements
To update your firmware:
– Unzip the firmware .zip file, and copy the “.bin” file over to a USB drive.
– Power on the HD Control Center. Insert the USB drive into the “Service” port in the rear after it has booted up fully.
– A message should appear on the screen. Confirm the update by selecting “Yes”.
– The front panel LEDs will flash in a pattern to signal activity during the
update process.
– The HD Control Center may reboot at some point – this is expected.
– Once the update is complete, the hub will return to normal.
The update will take somewhere between 5 to 30 minutes, depending on how many speakers you have in your system.
FEATURES
Adjust sound – Low volume bass boost
• Feature added
Status – speaker
• Improved information on speaker version and update handling
Status – firmware
• Linux and application version displayed
Advanced
• Power save mode control added
• HDMI pass through in (pseudo) standby added
Firmware update
• Improvements in displayed status during update process
Remote control codes
• Full set implemented
Other
• Improved CEC handling for certain TVs
BUG FIXES – MAJOR
Guided setup
• Better handling of non-standard speaker configurations.
Adjust sound – speaker levels
• Corrected levels played in sub and sub now correctly muted for non-sub level check
Adjust sound – subwoofer placement
• Corrected sub gain based on setting
Adjust sound – Audio enhancement
• Corrected bass boost in night mode and when switching modes
Advanced – Advanced speaker actions
• Improvements in handling move/add/remove for non-standard cases
Speaker update
• Handle cases where speaker flashwriter needs a special update before updating speaker software.
Speaker changes during operation
• Better handling of playback format speaker changes
USB sticks with no partition table
• Added ability to handle a wider range of USB sticks
Factory reset
• Occasional failures to restart after reset corrected
• Correct defaults set after reset
AC3 stream “PAUSE”
• Correctly mutes now
BUG FIXES – MINOR
Speaker LED status during updates and chime
• Hub correctly control speaker LED option (some features require updates
speaker software)
OSD
• Various cosmetic improvements
OTHER
• Smoother sample rate transitions
İndirme