Intellinet NFD130-IR Network Camera Firmware 1.6.03P7
Dosya tipi: Firmware.
Işleti̇m Si̇stemi: AnyOS.
Dosya adı: 7560.
Bit: 32/64 Bit.
Li̇sans: Ücretsiz.
Açıklama
Connecting to the Camera
Connect the RJ45 network cable from the camera’s LAN port to your network; e.g., the router or a LAN switch, then power on the camera. The boot sequence will take about one minute. You will need to use the camera’s power adapter, unless your camera supports PoE. In that case you can connect the RJ45 cable to a PoE-enabled switch or injector to power the camera.
By default, the network camera (or video server) searches for a DHCP server on the network and obtains an IP address automatically. A very common DHCP server is a router, a device that is found on most networks.
The presence of a DHCP server on your network simplifies the installation and users with limited knowledge of TCP/IP networks can install the network camera in minutes. If no DHCP server is found, the network camera will revert to its default IP address: 192.168.1.221.
İndirme