HP ENVY 17m-ce0000 Thunderbolt Oprogramowanie 1.0.60.1 do Windows 10 64-bit
Typ pliku: Oprogramowanie.
System Operacyjny: Windows 10.
Nazwa pliku: sp98906.exe.
Bit: 64 Bit.
Licencja: Darmowa.
Opis
This package provides the HP Thunderbolt Dock G2 Firmware Installer for supported computer models that are running a supported operating system.
This package includes the following firmware:
– Audio Base
– (Optional) Audio DSP
– (Optional) Audio Module
– USB3.1 Gen2 Hub
– DisplayPort Hub
– VGA Port
– Base Microcontroller
– US USB Type-C PD Controller
– DS USB Type-C PD Controller
– (Optional) Audio Module Microcontroller
– Thunderbolt Controller
Zmiany:
– Fixes an issue where the display is unstable when a certainDP2HDMI dongle is used with 4K60Hz DSC input only.
– Causes a DisplayPort monitor connected to the dock to run in HDMImode if the monitor EDID indicates it is an HDMI type but has noCEA extension block.
– Adds a workaround for certain sources that set input stream to 8bpc when the GPU enables HDR but has no VSC SDP packet and msa BPCis set to 6.
– Provides support to switch back to HDCP22 mode when the source is attempting to perform HDCP22 authentication after HDCP1.4 authentication has previously be performed.
– Resets the ESM (HDCP22 IP) block if there is no response.
– Adds a workaround for HPZR30W monitor DP input.
– Adds a workaround for LG5K monitor.
– Adds support for the GPU to switch the DSC ON/OFF on the same monitor.
– Extends the time allowed to select the minimal Display Port transmitter (DPTx) link rate based on timing requirements.
Jeśli został zainstalowany, aktualizacja (instalacja nadpisująca) może rozwiązać problemy, dodać nowe funkcje lub rozszerzyć istniejące. Nawet jeśli inne systemy operacyjne mogą być kompatybilne, nie zalecamy stosowania tej wersji na platformach innych niż określone.
Aby zainstalować ten pakiet, wykonaj następujące czynności:
– Upewnij się, że spełnione są wszystkie wymagania systemowe.
– Zapisz pakiet do pobrania w dostępnej lokalizacji (np. Na pulpicie).
– Zlokalizuj i kliknij dwukrotnie nowo pobrany plik.
– Zezwól systemowi Windows na uruchomienie pliku (jeśli to konieczne).
– Przeczytaj Umowę licencyjną użytkownika końcowego (Umowa licencyjna użytkownika końcowego) i zgódź się kontynuować proces instalacji.
– Postępuj zgodnie z instrukcjami wyświetlanymi na ekranie.
– Zamknij kreatora i ponownie uruchom system, aby zmiany odniosły skutek.
Pobierz