Ubiquiti EdgeRouter ER-X Router Firmware 2.0.4
Dosya tipi: Firmware.
Işleti̇m Si̇stemi: AnyOS.
Dosya adı: ER-e50.v2.0.4.5199165.tar.
Bit: 32/64 Bit.
Li̇sans: Ücretsiz.
Açıklama
Düzeltmeler:
– UNMS – Add support for UNMS v1.0
– Dnsmasq – Improve dnsmasq configuration time during initial boot
– Qos/Netflow – Fix bug that caused Qos/Netflow malfunction when offloading was enabled
– FactoryReset – Add eth9 LED blinking when doing factory reset on ER-10X
– LLDP – Fix regression in v2.0.1 when interfaces of switch ports did not transmit LLDP frames
– IPv6 – Add config validation that forbids simultaneous use of dhcpv6 and dhcpv6-pd
– Discovery – Fix bug when UBNT discovery did not work if UNMS was configured
– TechSupport – Add more IPSec info to tech-support file
– UPnP – Fix bug when UPnP rules were not properly flushed by “clear upnp2 rules” CLI command
– Offloading – Fix bug when syslog&console were filled with “protocol 0800 is buggy” error messages if gre offloading was enabled
– SFP – Fix bug when SFP status sometimes disappeared when SFP module was inserted
– Switch – Fix regression in v2.0.0 when counters of switch0 were not incremented on ER-12/ER-12P
– Switch – Fix potential packet leaking issue after detaching interface from switch0
– Interface – Fix bug when interfaces counters added in switch0 didn’t get updated on ER-10X
– Security – Fix bug when ER could be DOSed by opening unauthenticated WebGUI session that would lead to resource consumption
– Boot – Disable interactive prompt when installing new packages from “/config/data/firstboot/install-packages”
– Bootloader – Upgrade bootloader automatically for those ERs that have backup bootloader partition (ER, ERPro, ER-Infinity)
– Bootloader – Include the updated bootloader image for better scenario at TFTP recovery.
Known issues:
– Performance – Throughput degradation by 5-10% when comparing with v1.10.9 firmware with older kernel
– VPN – IPsec and VLAN offloading on ER-X/ER-X-SFP and EP-R6 does not work
– VPN – L2TP remote access VPN does not work with Android6/7 L2TP clients, but works with Android9 client though)
– LoadBalancing – LoadBalancing sometimes fails to recover after switching to failover interface
– WebGUI – Sometimes statistics in WebGUI is “freezing” and page refresh is needed in order to weke it up
– DPI – Sometimes DPI is reporting wrong rx/tx counters
İndirme