Ligowave NFT 1Ni Access Point Firmware 7.52
Dosya tipi: Firmware.
Işleti̇m Si̇stemi: AnyOS.
Dosya adı: NFT-1Ni_AP.QM-2.v7.52.12854.img.
Bit: 32/64 Bit.
Li̇sans: Ücretsiz.
Açıklama
What’s new in 7.52 firmware release
– Added UAM/CoovaChilli support (Throughput up to 60Mb/s)
– Added repeater mode with third party AP support
– Added router mode
– Added an option to close wireless session from RADIUS (RADIUS initiated disconnect) on WPA/WPA2-Enterprise
– Added option for indoor-outdoor channels-frequency filtering in list
– Added LAN speed indication over a single LED
– Added option to view DHCP server IP address leases
– Added IPv4 routing table management
– Added ping tool
– Added traceroute tool
– Added option to configure Ethernet speed
– Added multicast enhancements option
– Added “Network mode” to information page
– Added WAN and LAN IP subnets validation
Düzeltmeler:
– Fixed issue when “Save changes” button appears without any changes
– Fixed issue with VAP and wrong Data VLAN interface on bridge (NFT 1Ni)
– Fixed wrong PPPoE WAN ip address on WEB interface information section
– Fixed duplication of empty fields informational message
– Fixed IPv6 redirection
Improvements:
– Improved site survey to scan over 5/10/20 MHz channel widths
– Improved radio LED functionality indicating real data only
– Improved WPA/WPA2-Enterprise stability
– Changed antenna gain units to ‘dBi’
– Improved firmware upgrade process to avoid system corrupting
İndirme