Intel S2600KP Server Board UEFI Firmware 1.01.0016
Dosya tipi: Firmware.
Işleti̇m Si̇stemi: AnyOS.
Dosya adı: S2600KP_EFI_BIOS01010016_ME030103021_BMC01439685_FRUSDR114.zip.
Bit: 32/64 Bit.
Li̇sans: Ücretsiz.
Açıklama
sürümleri:
– System BIOS – R01.01.0016
– ME Firmware – 03.01.03.021
– BMC Firmware – 01.43.9685
– FRUSDR – 1.14
Update Procedure:
– Unzip the contents of the update package and copy all files to the root directory on a USB flash drive
– Insert the USB flash drive to any available USB port on the server system to be updated
– Power on the server
– The system will automatically access the uEFI shell and begin the update process.
Or
– If the files were copied to a folder other than the root, Boot the Server to the uEFI shell. This can be accessed via the <F2> BIOS setup utility during POST or via the <F6> Boot Menu accessed during POST.
– Run the command “map -r” in the uEFI shell to mount the USB flash drive
– Run the command “fs0:” to change folders to the USB flash drive. The USB flash drive may also mount to fs1: depending on other installed devices. The number of “fs#” is dependent on the result of command “map -r”
– Change folders to the folder holding the update package files and manually start the “Startup.nsh” script file to start loading all updates
– Reboot the system after the update process has successfully completed
Verifying Updates:
– During POST, hit the <F2> Key when prompted to access the BIOS Setup Utility
– From the BIOS Setup Utility main menu, Hit the <F9> key to load BIOS Defaults
– At the MAIN menu verify the BIOS revision is correct
– Move cursor to the SERVER MANAGEMENT Menu
– Move cursor down to the SYSTEM INFORMATION Option and hit Enter
– Verify the BMC Firmware revision is correct
– Verify the SDR revision is correct
– Verify the ME Firmware revision is correct
– Configure desired BIOS Option settings
– Hit the F10 Key to save changes and Exit
– The System Software Update is Complete.
İndirme