Hasselblad H2D Camera Body Firmware 2.2.4/16.0.6
Dosya tipi: Firmware.
Işleti̇m Si̇stemi: AnyOS.
Dosya adı: cb120131.zip.
Bit: 32/64 Bit.
Li̇sans: Ücretsiz.
Açıklama
Firmware version CB120131.hbf requires one of the following Hasselblad digital capture products: H4D, H3DII, H3D, H2D series.
Düzeltmeler:
– A bug which could cause incorrect angle measurements in True Focus to be applied after a lens change has been fixed.
Kurulum adımları:
1. Remove lens and viewfinder and connect the camera to the host computer using a FireWire cable.
2. Make sure the computer is powered from the mains supply or has a fresh battery.
3. Start Phocus and when the camera is connected, as indicated by an active camera icon in the top left part of the screen, select “Update Firmware…” from the “File“ menu.
4. Browse to the location where the update file was saved and follow the instructions on screen.
5. The update procedure will take a few minutes to finish. Depending on camera model, different options will be available during the update process.
Important notice:
– This firmware is not to be used with H1, H1D, H2 or H2F.
– Firmware updating is only possible via Phocus version 1.1.3 Mac, 1.0.2 Windows (or later).
– Do not use a PC laptop to perform this firmware update, as the firewire providence (it’s ability to provide enough power) may be to low. Attempts may render the sensor unit un-bootable. Should you experience this problem then perform the update on a stationary PC. This problem is not related to Mac computers.
İndirme