Ricoh WG-6 Camera Firmware 1.03
Tipo de arquivo: Firmware.
Sistema operacional: AnyOS.
Nome do arquivo: wg6_v103.zip.
Bit: 32/64 Bit.
Licença: Grátis.
Descrição
Following problems were corrected:
– Improved stability for general performance.
Formatting the SD memory card:
– If a card storing images is formatted, all data on the card will be lost. Save needed images to a computer in advance before formatting the card.
– Insert the SD memory card into the camera, and turn on the power to the camera
– Press the MENU/OK button
– Display the Setup Menu
– Select [Format [Card]] from the menu, and press the k button
– Select [Yes], and press the d/t button
Check the version of the firmware:
– With the camera turned off, while pressing the Down button, press and hold the Playback button down for 2 to 3 seconds
– Check the firmware version displayed on the picture monitor
– The part to check is the information that is encircled in the box below.
– The firmware version will be displayed on the picture display for about 20 seconds, after which the picture display screen will switch to the playback mode screen.
– Turn off the power to the camera
Install the new firmware version:
– Download and extract the firmware to your computer.
– A WG-6 Update folder will be created, and the firmware file, wlaunch3, will be extracted to the [Firmware relxxx (xxx is the version number)] folder.
– Copy the firmware to the SD memory card
– With the camera turned off, while pressing the Up button, press and hold the Playback button down for 2 to 3 seconds
– A message confirming the firmware update will appear on the picture display.
– Press the k button, select [YES], and press the C/D button
– The firmware update will start, and the message shown below will display on the picture display.The firmware update should take about 30 seconds to complete.
– After updating the firmware is completed, the power to the camera will once turn off automatically, and then the power will turn on in playback mode
– If there are no image files that have been taken with the camera saved to the SD memory card, the [No File] message will display.
– Turn off the power to the camera
– Check the firmware version of the camera once more.
Download