Buffalo WAPS-AG300H Access Point Firmware 1.16.1
Tipo de arquivo: Firmware.
Sistema operacional: AnyOS.
Nome do arquivo: wapsag300h-1161.zip.
Bit: 32/64 Bit.
Licença: Grátis.
Descrição
New Features:
– Now supports group administration for WLS-ADT.
Modified Features:
– Disables wireless functionality during firmware update because firmware may not be updated successfully when wireless functionality is enabled. Because of this modification, the progress bar will not refresh if the device is connected to the AirStation wirelessly. After the diag LED turns off, log in to Settings and check if the firmware version was updated.
– “STA Exceed maximum STA number of SSID.” message will be displayed on syslog when the maximum number of connected devices (configured in “Load Balancing” section on “Security” page) is reached.
– The signal strength displayed on “Wireless Monitor” and “Clients” page is described using RSSI(dBm).
– Session timeout will be 60 seconds when an unconfigurable value (1-59 seconds) is set.
Bug Correções:
– Fixed the issue where 11g beacon sometimes stopped.
– Fixed the issue where multiple VLAN settings did not function properly.
– Modified to reauthenticate without disconnecting wireless connection from a client after the session timeout if “Termination Action” attribute is “RADIUS-Request”.
– Fixed the issue where some wireless clients could not be authenticated using EAP authentication.
– Fixed the issue where the AirStation sometimes could not communicate with any registered access points when a MAC address on the access point list was deleted on [Wireless Settings]- [WDS] page.
– Fixed the issue where the wireless throughput sometimes dropped about 10-20% if VLAN settings of wired interface or WDS interface were changed when using WDS.
– Fixed the issue where the previous boot’s log was overwritten after restarting the AirStation when the log was configured to be transferred to a USB device.
– Fixed the issue where the number of packets could not be obtained properly from “ifInUcastPkts” object.
– Fixed the issue where the AirStation sometimes hanged up.
– Fixed the issue where the “ICV error” log was put out excessively when using WDS.
Download