Onkyo TX-NR696 A/V Receiver Firmware 1.17
Type de fichier: Firmware.
Système d’exploitation: AnyOS.
Nom de fichier: ONKAVR002E_R117.zip.
Bit: 32/64 Bit.
Licence: Gratuit.
Description
Changements:
– Support « Critical Listening mode of DTS Play-Fi ».
– Unlock IP/Serial/IR/Front Panel volume controls if using Sonos “Volume Pass-Through” feature.
– Minor bug fixes and improvements stability.
Update Procedure
– Connect a USB device to your PC. If there is any data in the USB device, remove it first.
– Téléchargez le firmware file.
– Décompressez le fichier téléchargé. The numbers of folders and files differ according to the model.
– Copy all the extracted folders including all folders and files to the USB device. Be careful not to copy the zip file.
– Remove the USB device from your PC and connect it to the USB port on the AV receiver.
– When the AV receiver has two USB ports, you can use either one.
– Make sure the AV receiver and TV are turned on.
– If the AV receiver is in standby mode, press 8ON/STANDBY on the AV receiver to light up the front display.
– Select the USB input source.
– “Now Initializing…” appears on the AV receiver’s display and then the name of the USB device is displayed. It takes 20 to 30 seconds to recognize the USB device.
– Press RECEIVER followed by HOME on the remote controller.
– The Home menu appears on the TV screen.
– Select “Firmware Update” and press ENTER.
– Select “Update via USB” and press ENTER.
– Note that this option will not be available if there is no firmware file newer than the currently installed version.
– Select “Update” and press ENTER.
– The update process will begin. During the update process, the on-screen display may disappear depending on the updated program. When this occurs, you can still view the update progress on the AV receiver’s display. The on-screen display will reappear after the update is complete, and upon turning the AV receiver off and on again.
– Do not turn off the AV receiver and do not remove the USB device during the update process.
– The message “Completed!” appears on the AV receiver’s display, indicating that the update has been completed.
– Retirez le périphérique USB.
– Press 8ON/STANDBY on the front panel.
– The AV receiver will enter standby mode.
– Do not use 8RECEIVER on the remote controller.
– The AV receiver will enter standby mode automatically in 3 minutes regardless of whether 8ON/STANDBY is pressed.
– Congratulations! You now have the latest firmware installed on your Onkyo AV receiver.
Télécharger