Buffalo WZR-600DHP Router Firmware 1.91
Type de fichier: Firmware.
Système d’exploitation: AnyOS.
Nom de fichier: wzr600dhp-191.zip.
Bit: 32/64 Bit.
Licence: Gratuit.
Description
[Specification change]
– Previous settings for IP address are now retained when switching between router mode and bridge mode.
– Media server renews database automatically when new media files are added.
– Added error message when no upper router is connected to the Internet while the AirStation is in auto mode.
[Added feature]
– Notification in settings when new firmware is released.
– The firmware update reminder can be disabled in ‘Admin’-‘Update’.
– Improved remote access function by registering network devices manually.
– To register a network device as static, navigate to ‘Setup’ – ‘Network Services’.
[Bug fix]
– Solved the problem where users with fixed IP addressed could not be registered to PPTP servers.
– Fixed the loss of connection to an ISP when the Internet port’s ONU power was turned on.
– Fixed bug where Easy Setup doesn’t connect the AirStation to the Internet with a specific ISP.
– Added message when IPv6 passthrough isn’t enabled while movie engine is on.
– LAN-side IP addresses are now blocked from use as WAN-side IP addresses in Port Forwarding.
– Added support for 2 TB and larger NAS drives.
– Fixed description error in settings.
How to update the firmware:
– Connect the AirStation to the same network as your PC. For best results, connect the AirStation directly to your PC with an Ethernet cable.
– Boot your PC.
– Confirm that the PC’s and the AirStation’s IP addresses are on the same network subnet. Refer to AirStation’s user manual to confirm how to change IP address settings.
– Open a browser and enter “192.168.11.1” in the URL field, then press the enter key.
– Enter “admin” for the username and “password” for the password. Note: If you changed the password, enter the password that you configured.
– Click “Update AirStation Firmware” at the left of the screen.
– Click “Browse” to the right of “Firmware File” and navigate to the firmware file.
– When the update starts, the power LED will blink red. It will take about 6 minutes to finish updating. When it finishes, the power LED will blink green or turn off. Do not disconnect power to the unit while the power LED is blinking red or your AirStation may be damaged.
– To confirm that your firmware is successfully updated, check the version number.
Télécharger