Kinesis Advantage2 Keyboard Firmware 1.0.168 Beta
Dateityp: Firmware.
Betriebssystem: AnyOS.
Dateiname: Advantage2_1.0.168.upd.
Bit: 32/64 Bit.
Lizenz: Kostenlos.
Beschreibung
Bugs fixed in 1.0.168
– Keypad LED now behaves properly when using Program Remap Mode to remap keys across layers.
– Status Report was sometimes delayed in correctly tabulating the number of keys remapped in the active layout.
– Custom programming of either of the two “Keypad Enter” positions in the Keypad layer was malfunctioning. For
direct editing now use the tokens [kpenter1] and [kpenter2] (see User’s Manual Section 13.1).
– Any key position can be disabled via direct editing using the [null] token.
To update the firmware, perform the following steps:
1. Obtain the appropriate version of Advantage2 firmware (“.upd” file)
2. If Power User Mode (PUM) has not been enabled, do so now (progm + shift + esc). All four LEDs will flash 4 times.
3. Open the v-drive (progm + F1).
4. Open the “firmware” folder.
5. Copy and paste the new firmware file into the firmware folder.
6. Rename the firmware file “update.upd”.
7. Optional: Unmount the v-drive.
8. Initiate Firmware Update (program + shift + U). The update process normally takes 10-12 seconds to complete, during which time the keyboard will be inactive.
IMPORANT NOTE: Do unplug or type on the keyboard during this step.
9. After 12 seconds, tap the Keypad key to test the keyboard. When the keypad LED illuminates the keyboard is active again.
10. Run a Status Report to confirm the new version of firmware was successfully installed.
11. If the keyboard does not wake up after 12-15 seconds, perform a Hard Reset (Right Ctrl + F9 while plugging it in).
Download