ZOOM G3n Multi-Effects Pedals Firmware 2.20
Dosya tipi: Firmware.
Işleti̇m Si̇stemi: Mac, Windows 10, Windows 8, Windows 8.1.
Dosya adı: G3n_v2.20_Mac_E_0.zip.
Bit: 64 Bit.
Li̇sans: Ücretsiz.
Açıklama
değişiklikler:
1. EDITOR View of Guitar Lab sometimes cannot be used.
2. USB connection is sometimes disabled after a certain period of time.
Installing the standard Windows driver on the computer:
– Connect the G3n to the computer using a USB cable. If you connect to a USB port that is different from the one that you used when installing the Windows standard driver previously, “Driver Software Installation” will appear.
– After a short time, the standard driver installation will complete.
Updating the firmware
1. Use a USB cable to connect the G3n to a computer.
2. While pressing both FS1 and FS2, turn the POWER switch ON.
2.1. NOTE: The firmware update requires the standard driver.
3. Double-click the firmware update application icon to launch.
4. With a G3n, click the “MIDI IN” and “MIDI OUT” fields to open lists of MIDI devices and select “ZOOM G Series” for both. If nothing is shown in the fields, click [Rescan Device] button.
5. Click the [Execute] button to start the firmware update.
5.1. Do not disconnect the USB cable while the firmware is being updated. In the unlikely event that a firmware update should fail, follow the procedures from the beginning to update the firmware again.
6. When the firmware update completes, click the [Exit] button to close the firmware update application. Then, turn the G3n power off. This completes the firmware update.
İndirme