Kramer VP-731 Presentation Scaler-Switcher Firmware 1.10 Master
Dosya tipi: Firmware.
Işleti̇m Si̇stemi: AnyOS.
Dosya adı: vp-730_731_master_firmware_upgrade_ver._1.10.zip.
Bit: 32/64 Bit.
Li̇sans: Ücretsiz.
Açıklama
The following changes were made in this version:
Added Features:
– New resolutions were added to the output resolution list: [email protected] [email protected] [email protected] [email protected] [email protected] [email protected]
– The EDID file is now read from any acceptor (through the HDMI) and stored as a custom output resolution. This allows automatic handling of LED screens that support very low non-standard resolutions.
– An option was added to select any audio source for the HDMI inputs. This allows the embedding of any other audio source into the HDMI video (besides the original HDMI audio source).
– HDCP support can now be enabled and disabled. This allows the source to transmit a non-HDCP signal if required.
Düzeltmeler:
– The double response for commands sent on RS-232 was fixed.
– When switching to HDMI sources with embedded audio, the small audible click or pop was fixed.
Modifications:
– HDCP timing and handling was improved.
Known Issues:
– When switching from an HDMI source to an analog or S/PDIF source, there is no audio output. (The audio works properly when switching between any sources that are not an HDMI source). To recover the audio, switch momentarily to any other analog source then back to the desired one.
– When selecting a different audio source to embed into the HDMI video source, pressing the +/- for the input audio level causes the unit to go into a mute state. To recover from the problem, switch to a different source and back to the original one.
Firmware Upgrade Procedure
1. Acquire xxx.brec file with the required version of firmware.
2. Copy this file to the route directory on any USB readable memory device (disk-on-key, flash memory card etc.).
3. Plug the device with the firmware file into USB connector of the VP728/729 and switch osan the scaler.
4. Wait until the scaler boots up and then use OSD menu to navigate to Setup>Advanced Setup>Misc>Firmware Download
5. Use UP and DOWN arrows to highlight the required firmware file and press ENTER button.
6. Confirm the upgrade and wait until progress indicator gets to 100%.
7. Restart the scaler by recycling the power.
İndirme