JVC DLA-X90RBU Projector Firmware
Dosya tipi: Firmware.
Işleti̇m Si̇stemi: AnyOS.
Dosya adı: 15125.ZIP.
Bit: 32/64 Bit.
Li̇sans: Ücretsiz.
Açıklama
Symptoms:
– Wrong color in Film modes Film 1/Film 2 (Cinema/3D/THX/Stage/Anime are OK).
– Wrong color in CMD 1 and CMD 2 in high lamp mode (low lamp mode/CMD off/ CMD 3 3/CMD 4 are OK).
– Black out when Screen Adjust is set to #123 (other values are OK).
Procedure:
1 Open the file SFCommander_Special_v006.zip.
2 Double click the file SFCommander_Special.exe to start up the software. 3. Prepare the Projector:
• Connect an RS-232c null modem (crossover) cable from the PC to the RS232C terminal at the rear panel. Avoid using a USB-to-RS232 adapter, since it may not be able to update with the USB-to-RS232 adapter.
• Connect any video source to the HDMI-1 input (i.e. blu-ray player).
• Power ON both the video source and the projector, then, change the projector INPUT to HDMI-1.
4. On the SFCommander window, make sure the PORT setting displays the correct RS232c COM PORT setting. Press the “Write Default” button on SFCommander to start writing.
– If operating normally, the progress bar of the application will advance.
5. When the writing completes successfully the following window should pop up on the PC monitor.
– Press the “OK” button on the pop up window.
Düzeltmeler:
– This update addresses Incorrect color may appear in certain modes.
İndirme