Peplink Balance 1350 HW2 Router Firmware 8.0.2
Tipo de arquivo: Firmware.
Sistema operacional: AnyOS.
Nome do arquivo: fw-b305hw2_380hw6_580hw2_710hw3_1350hw2_2500-8.0.2-build2721.bin.
Bit: 32/64 Bit.
Licença: Grátis.
Descrição
Feature Improvements:
– [WAN] Added custom ping target setting on SmartCheck
Applies for All Models
Resolved Issues:
– [AP Controller] Unable to apply AP One Firmware 3.7 to AP units
Applies for Balance: All
Applies for MAX: 700, HD2/4, Transit
Applies for MediaFast: All
Applies for X Series: EPX, SDX, MBX
– [AP Controller] Unable to show AP Firmware 3.7.1 in Firmware Pack if External AP Management has not enabled.
Applies for Balance: All
Applies for MAX: 700, HD2/4, Transit
Applies for MediaFast: All
Applies for X Series: EPX, SDX, MBX
– [Captive Portal] Fixed an issue that causes the captive portal to display the “502 Bad Gateway” error instead.
Applies for All Models
– [Cellular & Web UI] Under the menu “Cellular Settings > Failback to Preferred SIM when…”, the value of the variable “Non-preferred SIM is connected for…” cannot be set to 60 minutes or above, or else it will revert back to 1 minute.
Applies for Balance: LTE, 30 Pro
Applies for MAX: BR1/2, HD2/4, Transit
Applies for MediaFast: HD2/HD4
Applies for X Series: EPX, SDX, MBX
– [DPI] Fixed issues of DPI causing system instability.
Applies for All Models
– [Outbound Policy | Firewall Rules | IC2] Unable to push SaaS/Region Firewall & Outbound Policy Rules from InControl 2
Applies for Balance: All
Applies for MAX: All
Applies for MediaFast: All
Applies for X Series: EPX, SDX, MBX
Applies for Surf SOHO
– [Outbound Policy] The “terminate Session On Link Recovery” feature may not work if a higher Outbound Policy Rule has MAC address as Source.
Applies for All Models (Except FusionHub)
– [PepVPN] When both peers only have a single WAN, and if a WAN is unstable, PepVPN might not be
Applies for All Models
– [SDX] The front OLED panel may stop responding after setting the passcode.
Applies for X Series: SDX
– [SNMP] Fixed an issue where using both SNMP and multiple Layer 2 SpeedFusion Profiles together will cause high CPU load.
Applies for All Models
– [SpeedFusion] Fixed an issue where enabling SpeedFusion FEC causes system instability.
Applies for Balance: B210 or above
Applies forMAX: 700, HD2/4, Transit
Applies for MediaFast: All
Applies for SFE
Applies for X Series: EPX, SDX, MBX
Applies for FusionHub
– [URL Logging] Fixed an issue where the log is missing the date and time information.
Applies for All Models
– [USB WAN] If USB WAN is in use, InControl 2 may show the unit as offline.
Applies for Balance: All
Applies for MAX: BR1 ENT, HD2/4 Indoor Series
Applies for MediaFast: All
Applies for X Series: EPX, SDX, MBX
Applies for Surf SOHO
– [WAN Analysis] WAN Analysis may show “null” error during the start of the test.
Applies for All Models
– [Web UI] In rare cases, the “Apply Changes” button may be disabled after saving some changes.
Applies for All Models
Download