Casio EX-FR200 Camera Firmware 1.10
Tipo de arquivo: Firmware.
Sistema operacional: AnyOS.
Nome do arquivo: EX-FR200_110.zip.
Bit: 32/64 Bit.
Licença: Grátis.
Descrição
Alterar:
– Added capability to configure settings from EXILIM Connect smartphone/tablet terminal app
NOTE
– With the EX-FR200 camera, both the camera and controller firmware need to be updated.
– With the EX-FR200CA camera, just the camera firmware needs to be updated.
– EXILIM Connect version must also be updated
Precauções:
– Before updating the version, save images in camera memory to a computer or other device.
– Be sure to install both the camera and controller updates.
– Note that installation of the update software cannot be undone. Once you install the update software, there is no way to restore your camera to its original firmware version.
– If firmware update installation is interrupted due to low battery power, your camera will no longer be able to operate. Make sure the camera’s battery is fully charged before starting the firmware update installation procedure.
– When using battery power for installation, a safety feature makes it impossible to perform installation when battery power is low. Make sure the camera’s battery is fully charged when using battery power for installation.
– After copying the .BIN files to memory card, disconnect the USB cable from the camera before installing the firmware onto the camera. This firmware update cannot be installed while the USB cable is plugged into the camera.
To install the update software on your controller:
– Installation of this software requires a USB cable to connect the camera controller to a computer.
– Extract the file you downloaded.
– Use the micro USB cable provided with the camera to establish a USB connection between the camera controller and your computer.
– While holding down the controller’s movie button, press its power button and wait for a moment.
– The controller’s operation lamp will flash, indicating that the controller is being recognized as a removable disk.
– Copy the extracted file (FR100CT.BIN) to the root directory (not in a folder) on the controller/removable disk.
– After you finish copying the files, disconnect the USB cable from the controller.
– This causes controller power to turn off automatically.
– Use the micro USB cable provided with the camera to establish a USB connection between the camera controller and your computer.
– While holding down the controller’s movie button and shutter button, press its power button and wait for a moment.
– This will display a program update selection screen on the controller’s monitor screen.
– On the controller, press the shutter button to start program updating.
– Program updating takes about two minutes to complete.
– The controller LED will alternately flash red and orange while program updating is in progress.
– Disconnection of the micro USB cable while program updating is in progress will stop program updating.
– If this happens, open the controller’s USB cover, press the reset button, and then start again from step 6 of this procedure.
– Updating is complete when “SUCCESS” appears on the controller’s monitor screen.
– After program updating is complete, turn controller power off and then disconnect it from your computer.
To install the update software on your camera:
– Extract the file you downloaded.
– Load the memory card into the camera.
– Connect the camera to its USB cable and establish a USB connection with your computer.
– Copy the extracted files (camm1500.BIN and rom.BIN) to the root directory (the top directory on the drive) on a memory card.
– After you finish copying the files, turn off the camera and then disconnect the USB cable from the camera.
– On the camera, hold down the camera’s shutter button as you hold down the power button.
– The operation lamp will first light green.
– After some time, the operation lamp color will change to orange and the wireless LAN connection lamp will flash blue. This indicates that program updating has started.
– You can release the camera’s shutter button and power button at this point.
– The wireless LAN connection lamp will stop flashing and go out while program updating is in progress.
– After some time, the operation lamp color will change to red.
– Updating is complete when the Operation lamp goes out.
– Check if the firmware version has been updated.
– Remove the memory card from the camera.
Download