Buffalo WZR-900DHP Router Firmware 2.18
Tipo de arquivo: Firmware.
Sistema operacional: AnyOS.
Nome do arquivo: WZR-900DHP_FW2.18.zip.
Bit: 32/64 Bit.
Licença: Grátis.
Descrição
Version 2.18 [Bug fixes]
– Fixed some bugs in Settings.
– Fixed the issue where the AirStation in wireless bridge mode could not access to the master device using WEP.
– Fixed the issue where the error message for a competing IP address appeared when the AirStation is accessed from the device whose IP address is on a different segment from the LAN-side IP address of the AirStation.
– Fixed the issue where the AirStaion in wireless bridge mode kept connecting and disconnecting from a specific master device.
– Fixed the issue where the IP address was not renewed after time synchronization with the NTP server when the method of acquiring WAN-side IP address was set for “Acquire an IP address automatically from a DHCP server”.
– Fixed the issue where the secondary DNS server was not used when the AirStation could not connect to the Internet using the primary DNS server.
– Fixed the issue where wireless devices could find the AirStation that had been configured for sleep on eco Mode settings.
– Fixed the issue where the wireless connection of the AirStation was sometime unstable.
How to update the firmware:
– Connect the AirStation to the same network as your PC. For best results, connect the AirStation directly to your PC with an Ethernet cable.
– Boot your PC.
– Confirm that the PC’s and the AirStation’s IP addresses are on the same network subnet. Refer to AirStation’s user manual to confirm how to change IP address settings.
– Open a browser and enter “192.168.11.1” in the URL field, then press the enter key.
– Enter “admin” for the username and “password” for the password. Note: If you changed the password, enter the password that you configured.
– Click “Update AirStation Firmware” at the left of the screen.
– Click “Browse” to the right of “Firmware File” and navigate to the firmware file.
– When the update starts, the power LED will blink red. It will take about 6 minutes to finish updating. When it finishes, the power LED will blink green or turn off. Do not disconnect power to the unit while the power LED is blinking red or your AirStation may be damaged.
– To confirm that your firmware is successfully updated, check the version number.
Download