Buffalo LS520D NAS Firmware 4.30
Tipo de arquivo: Firmware.
Sistema operacional: Mac, Windows 10, Windows 7, Windows 8, Windows 8.1.
Nome do arquivo: LS500_series_FW_4.30.zip.
Bit: 64 Bit.
Licença: Grátis.
Descrição
Added and Modified Features:
– The LinkStation can now back up to another Buffalo NAS device on the network.
– The LinkStation can now use a UPS device that is connected to another Buffalo NAS device on the network.
– Username folders can now be hidden.
Bug Fixes
– [SMB]: Fixed a bug where a username folder could not be accessed right after rebuilding the RAID array.
– [Other]: – Fixed other minor bugs.
Caution:
– Please consult your local technical support representative if you experience any problems caused by this firmware update.
– Do not turn the unit off until the update is finished. It will take several minutes. You will receive a message when the update is finished.
– USB drives are not mounted automatically after a firmware update. To mount them, unplug and then reconnect them.
How to Use the Updater:
1. Connect the LinkStation properly and configure the LinkStation and a computer to run the updater on the same network subnet. The subnet masks should be the same and the first three numbers of the IP addresses should be the same. The last number of the IP addresses should be different.
For example, if the IP address and subnet mask of the computer are
” 192.168.0.10 , 255.255.255.0 “
and the IP address and subnet mask of the LinkStation are
” 192.168.1.150 , 255.255.255.0 “
then the updater will _not_ work properly.
In this case, reconfigure the LinkStation’s IP address and subnet mask to
” 192.168.0.150 , 255.255.255.0 “.
Then they will be on the same subnet and the updater will work properly.
2. Close all applications. Also, stop or exit any firewall software.
3. Extract the downloaded file and run “”LSUpdater.exe”. When a LinkStation is detected, an update window will open.
4. Select the LinkStation to update if multiple LinkStation are connected.
5. Click “Update” and enter the LinkStation’s admin password.
6. Click “OK”.
7. Transferring and updating the firmware will start. Wait until it finishes. The info LED will blink during the update.
8. When the update finishes, a message will be displayed.
Download