UCam247i NC308W-IR IP Camera Oprogramowanie 5.96B20151111
Typ pliku: Oprogramowanie.
System Operacyjny: AnyOS.
Nazwa pliku: FIRMWARE_EN_UCAM247_NC308W_IR_50HZ_V5.96B20151111.mfw.
Bit: 32/64 Bit.
Licencja: Darmowa.
Opis
How to update the firmware on your UCam247 camera
It is important that you take your time with the update and follow all the steps including the waiting times.
1) Launch the UCam247Live app on your iPhone, iPad or Android device and tap the left arrow to the right of your camera entry and then tap the Edit Settings icon . Now go to Advanced Settings > About Device and make a note of the IP address (e.g. the setup wizard will display this as 192.168.x.x or 10.0.x.x etc.).
2) Now type the IP address (e.g. if it is 192.168.0.5) into the address bar of your web browser as http://192.168.0.5 and hit return.
3) You should now be at the camera’s web interface. Click Setting and enter your login when prompted (Default username and password being admin and admin). But if you changed the password you need to enter that password.
4) Go to Task > Task Management and turn off ALL Tasks by unticking all the boxes under the Enable column. Click Apply.
5) Go to Tools > Firmware Upgrade
6) Click Continue > Browse (and locate the firmware from your desktop or wherever you have download it to on your computer) > Upgrade
7) At this point WAIT for the screen to refresh automatically NB: don’t click away from this screen once you have click Upgrade or the update will fail and you may corrupt the software in your camera rendering it unusable and the Warranty will become void
8) After a few minutes the update will finish automatically and you should simply follow the steps then shown on screen to complete the update install.
9) Once the camera has been rebooted you can now go back to Task > Task Management and turn on the Tasks you need again. Click Apply.
You should now be able to verify you have the latest firmware installed by clicking the System tab in the Setting section of the camera’s web interface. You can now use the camera as before.
Uwaga:
If the camera does not reappear in your browser after the reboot in Step 9 do the following:
a) Disconnect the power to the camera and after a couple of minutes reconnect the power and leave the camera a couple of minutes to reboot fully. Then check to see if you can access the camera again either in your web browser or the app on your phone/tablet.
b) If the above has not worked then you will need to power off the camera and connect the camera to your router with an ethernet cable. Now reconnect the power and after a couple of minutes check if you can see the camera via the mobile app. If you can you should check the WiFi settings to ensure they are still intact after the firmware update.
Pobierz