Strymon TimeLine Pedal Oprogramowanie 1.58
Typ pliku: Oprogramowanie.
System Operacyjny: AnyOS.
Nazwa pliku: timeline_firmware_1v58.zip.
Bit: 32/64 Bit.
Licencja: Darmowa.
Opis
What’s New:
– Added MultiSwitch EXP controller support with TAP, Bank, Preset, and Looper EXP modes.
– Added MIDICL global parameter to allow for turning off response to MIDI clock.
– Added input level test to TEST mode.
– Added MIDIST global parameter to turn on “send state on preset change”.
– Added Continue-Clock midi message to realtime midi handler.
– Improved MIDI thru.
– Improved TAP average precision.
– Improved MIDI throughput rate.
– Alias Looper MIDI note messages to higher octave.
What’s Fixed:
– Resolved issue where MIDI clock start/stops can cause loss of wet signal.
– Resolved issue in Looper where half speed only dubs right channel.
– Resolved display issue with invalid characters and decimal points in a name.
– Resolved issue where the Bank Up feature can get stuck.
– Resolved issue with Delay Trails cutting off when delay preset is BYPASSED while the pedal is set to FEEDBACK LOOP mode.
– Resolved issues with entering GLOBLS menu while in LOOPER mode.
– Resolved issue where FILTER effect does not apply to delay repeats in PRE location.
– Resolved issue where continuous midi commands may prevent GLOBLS mode from being entered.
– Resolved issue where using dual delay can cause loss of dry signal.
– Resolved bounds to midi clocking.
How to Update Your Pedal
Once your MIDI interface has been configured, you are now ready to update your Strymon pedal. Before proceeding with the following steps, make sure that your Strymon pedal is connected to your computer with a dedicated MIDI interface and that your Librarian software is open.
– Navigate to View > Software Update at the top of your window or screen.
– Click on “Install the Update”.
– After the update has successfully been installed, click “OK”.
– You can check in the bottom right corner of the Librarian to confirm the update was installed successfully.
Pobierz