Sound Devices 688 Field Mixer Oprogramowanie 2.11
Typ pliku: Oprogramowanie.
System Operacyjny: AnyOS.
Nazwa pliku: 688-firmware.
Bit: 32/64 Bit.
Licencja: Darmowa.
Opis
Zmiany:
– The Circle Take (@) button on the CL-12 is locked out while in record and now always applies to Current Take.
– Entering track names with no characters are not allowed. This is to prevent track name shifting issues.
Naprawiony:
– The REC button on the CL-12 now flashes during the record pending state.
– The 688 Power LED no longer disappears whenever CL-12 & CL-6 are both connected to mixer.
– Previously, when the SEL follows PFL feature was disabled, selecting an input channel’s PFL and SEL together, then pressing another SEL button would result in illumination of two SEL buttons on the CL-12. This has been fixed, so that when SEL follows PFL is disabled, the press of a single SEL button will replace selection of an earlier one.
– Eliminated zipper noise when attenuating X1 and X2 track levels.
– Eliminated stepping noise when attenuating L, R, X1, X2 output levels.
– Reduced headphone monitor noise when adjusting headphone gain.
– Fixed a rare issue where user settings could be lost over power cycles.
– Fixed a rare issue where CL-12 power warning messages could appear at boot up.
– Fixed an issue where changes to the CL-12’s L, R, X1, and X2 pot positions were not being read after a cold boot.
– Fixed an issue where the CL-12 was showing internal tone 2 dB higher on its meters.
– NP1 to DC switchover with an SL-6 connected is now fixed.
Firmware Installation Instructions:
– Download the 688 firmware file.archive
– From the zip , extract the file within. Copy this .prg file to the root level of an approved SD or CF memory card. Do not place the file in any folder. Do not place the zip file on the SD or CF card. The card must be formatted in the 688.
– Apply Update to 688.
– Power the 688 from external DC. Do not perform the update with low batteries or unstable power sources.
– Power down the 688 if it is already powered up.
– Insert the SD or CF card with the .prg file.
– Power on the 688.
– Navigate to Setup Menu option SYSTEM > Update Firmware and follow the on-screen instructions.
– When the update is complete the 688 will power cycle itself. The version number will be displayed briefly on the splash screen while booting up. A message box appears „Firmware updated successfully Version:688_XXX”. Press „OK”. Please note any changes or additions to the Setup Menu (if applicable). Consult the 688 User Guide and Technical Information for details.
Pobierz