Sony ILCE-5100 Camera Oprogramowanie 3.10
Typ pliku: Oprogramowanie.
System Operacyjny: Windows 10, Windows 7, Windows 8, Windows 8.1, Windows Vista.
Nazwa pliku: Update_ILCE5100V310.exe.
Bit: 64 Bit.
Licencja: Darmowa.
Opis
Poprawki:
– Phase-detection AF is supported
– The lens name will be correctly recorded in the EXIF
– The AF can be used in movie recording mode with the SEL85F14GM
Download and Update the Firmware:
– IMPORTANT: Do not allow the computer to enter Sleep (Standby) mode during the update process.
– Pobierz oprogramowanie sprzętowe file to a temporary or download directory.
– Go to the directory where the file was downloaded and double-click the downloaded file to begin the Firmware Updater.
– Connect the camera to your computer using the supplied USB cable.
– The LCD screen on the camera will turn off when it is connected to the computer. If the LCD screen of camera does not turn off, disconnect and reconnect the USB cable to the camera. If the computer has additional USB ports, try connecting the USB cable to different USB port.
– Verify that the Remove Hardware icon or is displayed in the task tray at the lower right-hand corner of the computer screen.
– At the Firmware Updater screen, click Next.
– Do not power off the camera or disconnect the USB cable until the update process is complete.
– When the next screen is displayed, check the version number at the lower left and click Next.
– When the next screen is displayed, click the Remove Hardware icon or in the task tray to stop the USB connection. If the Remove Hardware icon is not displayed on the task tray, please proceed to the next step.
– Do not disconnect the USB cable from the camera or the computer.
– On the camera, press the center button of the Control Wheel to reset the camera.
– When the next screen is displayed, click Run.
– Do not power off the camera or disconnect the USB cable until the update process is complete.
– The update process takes about fifteen minutes to complete.
– After clicking Finish, make sure to wait for the camera screen to turn back on before you continue, this may take a few minutes.
– Click the Remove Hardware icon or in the task tray to stop the USB connection, and then disconnect the USB cable.
– Power off the camera, then remove the battery pack or AC adapter.
– Reconnect the battery pack or AC adapter and power on the camera.
Pobierz