Sony DSC-RX100M5 Camera Oprogramowanie 1.01
Typ pliku: Oprogramowanie.
System Operacyjny: Windows 10, Windows 7, Windows 8, Windows 8.1, Windows Vista.
Nazwa pliku: Update_DSCRX100M5V101.exe.
Bit: 64 Bit.
Licencja: Darmowa.
Opis
This update only applies to DSC-RX100M5 cameras that currently have a firmware version 1.00. If your camera firmware version is already version 1.01, this update is not necessary.
Check the version of your camera firmware:
– Power on the camera.
– Press the Menu button.
– At the Menu screen, use the Control Wheel to select Setup, and then select Version.
– The firmware version is displayed on the LCD screen.
– If the current firmware version is 1.01 or higher, the camera does not need this update.
– Press the center button of the Control Wheel to close the version number display.
Download and Update the Firmware
IMPORTANT: Do not allow the computer to enter Sleep (Standby) mode during the update process. To change your settings, please refer to your computer manual or consult the manufacturer.
– Download the Update_DSCRX100M5V101.exe file to a temporary or download directory (please note this directory for reference).
Uwaga:
For Windows 8/8.1 and 10, the default settings for Internet Explorer® will save the file in the Downloads folder. For Windows 10, use File Explorer to locate the Downloads folder, for Windows 8/8.1, click the Desktop tile from the Start screen and then locate the downloaded file using Windows Explorer.
– Go to the directory where the file was downloaded and double-click the Update_DSCRX100M5V101.exe file to begin the updater.
– The System Software Updater starts.
– Press the Menu button on the camera.
– At the Menu screen, use the Control Wheel to select Setup, USB Connection, and then ensure that Mass Storage is selected.
– Connect the camera to the computer with the supplied USB cable.
Note:
On the camera screen, USB Mode is displayed.
– When the updater recognizes the camera connection, the following screen is displayed.
– Confirm that Current version is Ver.1.00, and that the Version after the update is Ver.1.01, then click Next.
Note:
If the Current version is 1.01, this update is not needed. Stop the USB connection, and click Finish.
– The following screen appears and the camera automatically resets.
– After the camera resets, the following screen appears and the update starts.
Note:
The progress bar is displayed during the update which takes about 15 minutes.
WARNING:
Do not power off the camera or disconnect the USB cable during the update.
– When the update is complete, the camera will automatically restart and the following screen is displayed.
– Wait until the camera finishes restarting, click Finish, and then disconnect the USB cable.
Note:
After restarting, the message Recovering data Please wait… may rarely display. This is normal, please wait until this message goes away.
Pobierz