Pelco Sarix IWP121-1ES IP Camera Oprogramowanie 1.16.14
Typ pliku: Oprogramowanie.
System Operacyjny: AnyOS.
Nazwa pliku: IWP121-1ES Firmware v01.16.14.zip.
Bit: 32/64 Bit.
Licencja: Darmowa.
Opis
Operational Issues
– Using Pelco Utilities to update camera firmware, there is a delay of 4.5 minutes before the update process starts.
– WS5000 software may hang when users enable motion. Close the Setup tab and reopen to correct the issue.
– When changing the threshold percentage for motion in the WS5000 software, exiting the Setup tab will cause the software to revert to the default value (100%), even if you save your changes.
– The frame rate shown in camera settings in the Endura Workstation (WS5000) software is incorrect. It is half of what it is supposed to be.
– There is no option to select and change video stream settings in Milestone using the Pelco driver.
– The 802.1x uploaded certificate is not visible in the Pelco GUI after a reboot.
Upgrading Firmware From Camera Web Interface
1. Use Internet Explorer to access the camera via its IP address.
2. Click on the Login link in the upper right corner of the page and then enter credentials for the administrator.
3. Click Settings and then navigate to the Firmware page under the System menu.
4. Click Browse to select the firmware file and then click Upload.
The camera will install the updated firmware and then restart. The firmware update process typically takes up to 5 minutes to complete.
Pobierz