Panasonic WV-SC386 Network Camera Oprogramowanie 2.00
Typ pliku: Oprogramowanie.
System Operacyjny: AnyOS.
Nazwa pliku: sw396_200E_cam_157.zip.
Bit: 32/64 Bit.
Licencja: Darmowa.
Opis
Zmiany:
– Added FTP transmitting Pre alarm picture.
– Added hyper-link to the „Support Information on network camera (WV Series)” in the page of firmware upgrade.
– Changed the name of „Direction setting” to „Direction/Angle setting”. Added „Panning 0-deg direction setting”.
– Added Audio Output Duration setting so that various durations of audio transmission (such as 1/2/3/5/10/20/30/60min) can be set (instead of 5-min fixed).
– Added „High Light Compensation (HLC)” function
– Added „Alarm deactivation time” setting so that various deactivation time (such as 5s/10s/30s/1min/3min/5min/10min) can be set (instead of 5-sec fixed).
– Made possible to choose „BASELINE” or „HIGH” as H.264 Profile by CGI command.
– Improved sensitivity for VMD by CGI command.
– Improved outputting frame rate while setting Max. bit rate were lower value in Advance Variable Bit Rate (AVBR).
– E-mail notification can attach an image when recording video is in use.
– In ONVIF, supported Video Source Mode (Image Capture Mode) command.
– In ONVIF, supported Audio Back Channel over HTTP.
– By CGI command, unable to obtain the desired MP4 file(s) only but also all associated MP4 files will be obtained. (Occurrence frequency: High)
– In a case, the subject were a certain specific brightness.
– Fixed only desired MP4 file(s) to be obtained.
– Unable to set durations of pre-alarm and postalarm recordings.
– Set H.264(2) to „OFF” while recording H.264(1) onto SD memory card.
– Fixed to set the durations.
– Time stamp information may not be on the stream.
– (Occurrence frequency: Low) When error occurred at H.264 video transmission.
– Fixed to the stream contains time stamp information.
– Improved the returning of CGI command (/cgi-bin/find_recording_seqs) would contain „Content-Length”.
Pobierz