Intel S2600IP Server Board UEFI Oprogramowanie 2.06.0005
Typ pliku: Oprogramowanie.
System Operacyjny: AnyOS.
Nazwa pliku: S2600IP_W2600CR_EFI_BIOS02060005_ME020107328_BMC0127r9958_FRUSDR112.zip.
Bit: 32/64 Bit.
Licencja: Darmowa.
Opis
Wersje:
– System BIOS – 02.06.0005
– ME Firmware – 02.01.07.328
– BMC Firmware – 01.27.9958
– FRUSDR – 1.12
Zmiany:
– Hotfix for security hole about RtcRead.
To pobieranie jest ważne dla produktów wymienionych poniżej:
– Intel Server Board S2600IP4
– Intel Workstation Board W2600CR2
– Intel Workstation System P4304CR2LFKN
– Intel Workstation System P4304CR2LFJN
– Intel Workstation System P4304CR2LFGN
– Intel Server System R2224IP4LHPC
– Intel Server System R2216IP4LHPC
– Intel Server System R2208IP4LHPN
– Intel Server System R2312IP4LHPC
– Intel Server System R2308IP4LHPR
– Intel Server System R2304IP4LHPN
– Intel Server System P4224IP4LHKC
– Intel Server System P4224IP4LHJC
– Intel Server System P4216IP4LHKC
– Intel Server System P4208IP4LHKC
– Intel Server System P4216IP4LHJC
– Intel Server System P4208IP4LHJC
– Intel Server System P4216IP4LHGC
– Intel Server System P4208IP4LHGC
– Intel Server System P4308IP4LHKC
– Intel Server System P4308IP4LHJC
– Intel Server System P4308IP4LHGC
– Intel Server System R2208IP4LHPC
– Intel Server System R2308IP4LHPC
– Intel Server System P4XXXIP4LXXC
– Intel Server Board S2600IP4L
– Intel Workstation Board W2600CR2L
– Intel Server System P4308IP4LHJCL
– Intel Workstation System P4304CR2LFJNL
Update Procedure:
– Unzip the contents of the update package and copy all files to a folder on a USB flash drive
– Insert the USB flash drive to any available USB port on the server system to be updated
– Boot the Server to the EFI shell. This can be accessed via the <F2> BIOS setup utility during POST.
– Run the command “map -r” in the EFI shell to mount a USB flash drive formatted to use the FAT32 file system
– Run the command “fs0:” to change folders to the USB flash drive. The USB flash drive may also mount to fs1: depending on other installed devices. The number of “fs#” is dependent on the result of command “map -r”
– Change folders to the folder storing the update package files
– Run the command “Startup.nsh” to start updating all the firmware and BIOS updates
Verifying Updates:
– Reboot the system
– During POST, hit the <F2> Key when prompted to access the BIOS Setup Utility
– Hit the F9 key to load BIOS Defaults
– At the MAIN menu verify the BIOS revision is correct
– Move cursor to the SERVER MANAGEMENT Menu
– Move cursor down to the SYSTEM INFORMATION Option and hit Enter
– Verify the BMC Firmware revision is correct
– Verify the SDR revision is correct
– Verify the ME Firmware revision is correct
– Hit the F10 Key to save changes and Exit
Pobierz