HackHD Camera Oprogramowanie 1.1.15
Typ pliku: Oprogramowanie.
System Operacyjny: AnyOS.
Nazwa pliku: main.elf.
Bit: 32/64 Bit.
Licencja: Darmowa.
Opis
Zmiany:
– One firmware for all options customizable via a config.txt file that must be on SD card
– Photo mode added with options
– Video record length can be set
– Exposure option (for bright or dim light settings)
– Option to set the time
– Audio volume setting with mute
– Firmware and watermark display option
Continuous recording:
– When the microSD runs out of memory, the oldest video will be deleted to allow for indefinite recording (providing there is power).
– 2 to 3 seconds of footage will be lost in between videos.
– Example application would be as a security camera by connecting the HackHD to a DVR for months worth of non HD recording on a hardrive and have up to the last 48 hours (on a 256GB SD card using our microSD to SD card adapter) of footage available in full 1080P HD if a crime occurs.
Firmware Installation Instructions:
It is crucial these instructions are followed correctly otherwise the HackHD can become permanently defective. If you are having problems installing the new firmware, try first formatting your SD card in Fat32, NTFS, exFAT or trying another card before putting main.elf on it.
1. Put the firmware file (always called main.elf) in the root directory on your microSD card.
2. Insert the microSD and connect an LED, switch, and fully charged battery or external power supply (between 3.7V and 5.5V) to the board.
3. Power up the camera in standby mode. You will know it is in standby mode with the LED remains solid. If the LED beings slowly flashing, it is possible the camera either booted up in auto mode or was accidentally triggered to start recording in standby mode. If this is the case, press the switch again, if the LED goes solid, the camera is in standby mode ready for the next step. If the LED turns off, the camera was in automode so try again to enter standby mode.
4. Once you confirmed the camera is in standby mode and not recording, hold down the switch. After a few seconds, the LED will turn off and then a few seconds later the LED will turn back on. As soon as the LED turns on, immediately release the switch, it is important to do this within half a second of the LED turning back on. The LED will remain on for up to 30 seconds at which point it will turn off with the camera. When the LED turns off, the firmware upgrade should be successful. The video out signal shows the firmware version on the bottom of the feed.
Pobierz