Emerson RPC2 Communications Module Oprogramowanie 10.0.0.2_96704
Typ pliku: Oprogramowanie.
System Operacyjny: AnyOS.
Nazwa pliku: RPC2_10.0.0.2_96704.zip.
Bit: 32/64 Bit.
Licencja: Darmowa.
Opis
Ten pakiet zawiera niezbędne pliki instalacyjne Emerson RPC2 Communications Module Firmware w wersji 10.0.0.2_96704.
Features/Enhancements:
– Reboot button added to certain System tab pages whenever a restart is required, before configuration changes take effect (Web UI).
– A USB memory stick facilitates initial setup of networking, protocol and device configurations. Insert the memory stick into the RPC2 USB port using a Type A female to micro A/B male adaptor.
– There is a new discovery method when one of the following conditions occurs: The RPC2 unit reboots/ The first sensor is connected/ A sensors are disconnected/ After adding or removing one or more sensors (Click the Discover icon on the Sensors-Config page to discover the new configuration).
Poprawki:
Web UI
– HTTPS supported on Link/Management port.
– The % utilization colored bars are displayed within bounds of scrollable list.
– There is now an iconic display of state and lock conditions for a receptacle group.
Command Line Interface
– Telnet session starts immediately for static ip configuration by clearing DNS settings.
– The current threshold command using “@’ parameter configures complete PDU or bank.
– Consistent power commands response formatting.
– The network dns test type command returns Fully Qualified Domain Name for that configured mode verification.
– The system session timeout command replies (secs) unit label removed since value is either hours or minutes.
– The system agent command returns properly described listed values.
– The datalog interval command returns expected interval value.
– Response of commands returning the correct branch values as referenced by MPXBRM ID.
– Support configuration of IPV6 address format.
– Corrected grammatical errors in some response strings.
SNMP
– IPV6 addressing support.
Configuration
– Added Power Up State column at Device Explorer-List-Config page.
Networking
– Obtaining DNS Server IPv6 address.
– Obtaining stateful address from IPv6 DHCP server.
– Entering IPv6 address for TFTP or FTP server for firmware updates.
– Handling of saving empty IPv6 Link Local address field.
– IPv6 Link Local address field displays stateful or stateless address.
– Establishing a network connection using an IPv6 address in browser’s URL.
– Sending DNS Test query for IPV6.
– Interaction of DHCP and auto-indexing for array discovery process no longer requires a reboot or power cycle to adapt to networking or cabling changes. If DHCP mode is configured, but no active DHCP server is present, then the auto-indexing mode will persist for approximately 40 seconds. Afterwards, it will revert automatically to DHCP mode indefinitely until the network cabling is disconnected for greater than 10 seconds, whereupon a re-connection will repeat the process.
Data Logging
– Voltage column heading for “L3-N” was previously reporting “L2-N” heading.
Event Notification
– Reboot can be initiated from MPH2 on-board LCD.
– A Too Many Sensor Alarms message is reported if greater than ten sensors connected to a single RPC2.
Sensors
– Adding and removing sensors after initial sensor string is discovered now requires clicking the Discover icon on the Sensor-Configuration page to re-discover the newly configured string.
– The Sensor-Configuration page user label information previously was reporting serial numbers.
– Sensor hysteretic threshold processing requires measurement to persist for five seconds above or below configured threshold before an alarm is made active or cleared, respectively.
– Improved resiliency and immunity from transient EMI to mitigate false positive alarms and absent/new sensors reporting.
DSView/RPM
– Remote authentication now supports TLSv1 protocol.
General Fixes
– Alphanumeric, space, and ~!#$_+`-={
Pobierz