Actiontec SBWD100A WiDi Receiver Oprogramowanie 1.2.7.0
Typ pliku: Oprogramowanie.
System Operacyjny: AnyOS.
Nazwa pliku: sbpro_fw_1.2.7.0.zip.
Bit: 32/64 Bit.
Licencja: Darmowa.
Opis
Poprawki:
– Added Feature: GEN5 fast cursor.
– Changed: Enable UIBC by default
– Fix: Invisible fast cursor with UIBC movement.
Upgrade Instructions:
– Download and save ScreenBeam Pro’s firmware (sbpro_fw_x.x.xx.x.zip) to your Windows desktop or C:\ drive.
– Use either WinZip or Windows Explorer to extract the zip file. You should see the „autorun” folder, the „install” file and this upgrade instructions guide.
– Insert your USB flash drive to an available USB port on your Laptop/PC.
– Copy both the „autorun” folder and „install” file to the top directory of the USB flash drive.
– Note: Do not use a portable hard drive. You should use a formatted FAT/FAT32 USB flash drive only.
– Make sure the HDTV connected to the Receiver is powered on and the correct HDMI input is selected.
– Note: You must disconnect all wireless devices (ultrabooks, smartphones and tablets) from the Receiver before upgrading the firmware.
– When the “Ready to Connect” screen appears, plug the USB flash drive into the Receiver’s USB Port.
– Wait a few seconds and the firmware upgrade will start automatically. You should see the Firmware Upgrade message appears on your TV.
– Note: The HDTV screen may go temporarily blank for a few seconds during the upgrade process.
– Warning! Do not power off the Receiver or remove the USB flash drive while the upgrade is in progress. This may cause the firmware upgrade to fail.
– When the upgrade completes, the “Ready to Connect” screen reappears on the HDTV, with the new firmware version information displayed at the bottom right corner.
– The ScreenBeam Pro Receiver is now upgraded. You can remove the USB flash drive from the Receiver.
Pobierz