Sony ILCE-7RM2 Camera Firmware 3.20 per MAC OS
Tipo di file: Firmware.
Sistema Operativo: Mac.
Nome del file: Update_ILCE7RM2V320.dmg.
Bit: 32/64 Bit.
Licenza: Gratis.
Descrizione
Questo pacchetto fornisce i file di installazione necessari di Sony ILCE-7RM2 Camera Firmware 3.20 for MAC OS.
miglioramenti:
– Allows the camera to record XAVCS format video with an SDHC card in addition to SDXC card.
Notes:
– When an SDHC memory card is used to record movies in XAVC S format over extended periods of time, the recorded movies will be divided into files of 4 GB, and the divided files can then be integrated into a single file using the PlayMemories Home software
– Shooting movies in XAVC S format requires SD Speed Class 10, UHS Speed Class U1, or faster
– When recording at 100 Mbps or more, UHS Speed Class U3 is required
Download and Update the Firmware:
– IMPORTANT: Do not allow the computer to enter Sleep (Standby) mode during the update process.
– Scarica il firmware file to a temporary or download directory.
– Go to the directory where the file was downloaded and double-click the downloaded file to begin the Firmware Updater.
– Connect the camera to your computer using the supplied USB cable.
– The LCD screen on the camera will turn off when it is connected to the computer. If the LCD screen of camera does not turn off, disconnect and reconnect the USB cable to the camera. If the computer has additional USB ports, try connecting the USB cable to different USB port.
– Verify that the Remove Hardware icon or is displayed in the task tray at the lower right-hand corner of the computer screen.
– At the Firmware Updater screen, click Next.
– Do not power off the camera or disconnect the USB cable until the update process is complete.
– When the next screen is displayed, check the version number at the lower left and click Next.
– When the next screen is displayed, click the Remove Hardware icon or in the task tray to stop the USB connection. If the Remove Hardware icon is not displayed on the task tray, please proceed to the next step.
– Do not disconnect the USB cable from the camera or the computer.
– On the camera, press the center button of the Control Wheel to reset the camera.
– When the next screen is displayed, click Run.
– Do not power off the camera or disconnect the USB cable until the update process is complete.
– The update process takes about fifteen minutes to complete.
– After clicking Finish, make sure to wait for the camera screen to turn back on before you continue, this may take a few minutes.
– Click the Remove Hardware icon or in the task tray to stop the USB connection, and then disconnect the USB cable.
– Power off the camera, then remove the battery pack or AC adapter.
– Reconnect the battery pack or AC adapter and power on the camera.
Download