Edimax PT-31E Network Camera Firmware 1.02.04
Tipo di file: Firmware.
Sistema Operativo: AnyOS.
Nome del file: PT-31E_Firmeare_ReleaseNote_Ver.1.02.04_En.zip.
Bit: 32/64 Bit.
Licenza: Gratis.
Descrizione
3Mpx PoE Day & Night PT Network Camera
– 5 megapixel CMOS sensor
– Motorized pan and tilt
– Night vision with built-in IR LED (up to 10 meters)
– QXGA resolution at 20fps, 1080p resolution (full HD) at real-time 30fps
– H.264, MPEG-4 & M-JPEG multi-stream output
– Simultaneous live monitoring and high resolution recording
– Multi-area motion detection
– Support IEEE802.3af Power-over-Ethernet (PoE) standard
– SD/SDHC memory card slot for local storage
– 2-way audio support
Correzioni:
Web:
1. Revise the fail of Restore configuration
2. Set 0.0.0.0 as acceptable netmask
3. Remove the debug message when DDNS pops up
4. Fix image overlap when using Safari as management interface
5. Fix the improper display of Motion Satus bar
OCX :
1. Allow image showing in the 2nd session simultaneously
2. Improve MJPG (RTSP) and Win7 media player compatibility
3. OCX shows connecting message while network reconnects
4. Improve MPEG4 (RTSP/HTTP) and media player compatibility
5. Motion Window disappears
FW:
1. Device should have default DNS IP address before getting IP address from DHCP
2. Revise UPNP function
3. Improve the compatibility of HTTP MJPG record and media player
4. Define Non-supported GPIO sending back HTTP streaming header default=1 such as SIU7110 GPI2, SIU5110 GPI and GPO
5. Revise Event Schedule Time Check function
6. Resend RTSP MPEG4 VOL in order to keep the image stream in the 2nd OCX connection
7. Enable frame rate ? 20fps in param.cgi MJPEG 720P mode
8. MJPEG frame rate should refer to the defaul value but not 30fps when AV server reboots
9. Keep enough time for firmware upgrade completely
Download