Buffalo LS510D NAS Firmware 4.50
Tipo di file: Firmware.
Sistema Operativo: Mac, Windows 10, Windows 7, Windows 8, Windows 8.1.
Nome del file: LS500_series_FW_4.50.zip.
Bit: 64 Bit.
Licenza: Gratis.
Descrizione
Bug Correzioni:
– [SMB] Modified to patch a Samba programming vulnerability (CVE-2019-3880).
– [Folder Setup] Fixed a bug where it took a long time until the shared folders become accessible after recovering from sleep mode.
– [Others] Fixed a bug where unknown events occurred after booting up or recovering from sleep mode.
– [Others] Fixed a bug where the displayed used space percentage exceeds 100% on NAS Navigator2.
– [Others] Fixed a bug where the I18 message occurred on the first Sunday of every month.
Caution:
– Please consult your local technical support representative if you experience any problems caused by this firmware update.
– Do not turn the unit off until the update is finished. It will take several minutes. You will receive a message when the update is finished.
– USB drives are not mounted automatically after a firmware update. To mount them, unplug and then reconnect them.
How to Use the Updater:
1. Connect the LinkStation properly and configure the LinkStation and a computer to run the updater on the same network subnet. The subnet masks should be the same and the first three numbers of the IP addresses should be the same. The last number of the IP addresses should be different.
For example, if the IP address and subnet mask of the computer are
” 192.168.0.10 , 255.255.255.0 “
and the IP address and subnet mask of the LinkStation are
” 192.168.1.150 , 255.255.255.0 “
then the updater will _not_ work properly.
In this case, reconfigure the LinkStation’s IP address and subnet mask to
” 192.168.0.150 , 255.255.255.0 “.
Then they will be on the same subnet and the updater will work properly.
2. Close all applications. Also, stop or exit any firewall software.
3. Extract the downloaded file and run “”LSUpdater.exe”. When a LinkStation is detected, an update window will open.
4. Select the LinkStation to update if multiple LinkStation are connected.
5. Click “Update” and enter the LinkStation’s admin password.
6. Click “OK”.
7. Transferring and updating the firmware will start. Wait until it finishes. The info LED will blink during the update.
8. When the update finishes, a message will be displayed.
Download