Roland A-70 Expandable Controller Firmware 1.02 pour Mac OS
Type de fichier: Firmware.
Système d’exploitation: Mac.
Nom de fichier: A70v102.sea.hqx.
Bit: 32/64 Bit.
Licence: Gratuit.
Description
New Features:
– Version 1.02 adds the ability to control the new VE-GSPro Voice Expansion Board directly from the A-70 front panel.
Use the following procedure to update the operating system:
1) Power off the A-70.
2) Connect the MIDI OUT of the sequencer to the MIDI IN2 of the A-70.
3) Connect pedals to the HOLD and FS jacks of the A-70.
4) Load the _00001.MID MIDI file into your sequencer.
NOTE:This procedure will erase the contents of the user memory of the A-70. As necessary, save the user memory to a memory card or to a sequencer via system exclusive.
5) Press both pedals, and while holding down the OUT 1 button, turn the power on.
6) The LCD should display ‘UPDATA [******-*].’
7) Playback the first .MID file (_00001.MID).
8) After the sequence has completed playback, press ENTER on the A-70.
9) After ‘B1: 4FFF Update?’ is displayed, press ENTER again.
10) After ‘Erase -> Write -> CE9A-CE9A OK’ is displayed, press ENTER.
11) Repeat steps 8-11 with MIDI files ‘_00002 – 00008.’
12) After the last file has been completed and verified, turn off the A-70.
13) Hold down the MANUAL button and turn the power on to enter the Factory Reset mode.
14) Press ENTER to complete the initialization.
* When using the Roland XP-50/80 it will be necessary to play these
files directly from disk.
NOTE:
If you are not able to operate the BENDER/MODULATION lever after
following the above procedure, you may need to reassign this controller to its initial settings. Use the following procedure:
1) Press EDIT so that it is lit.
2) Move the BENDER/MODULATION lever to the right and use the VALUE INC/DEC buttons to select ‘Ch.M > PITCH BEND.’
3) Move the BENDER/MODULATION lever forward and use the VALUE INC/DEC buttons to select ‘CC > MOD :1.’
Télécharger