Kramer VP-731 Presentation Scaler-Switcher HDMI EDID Firmware 1.07
Type de fichier: Firmware.
Système d’exploitation: AnyOS.
Nom de fichier: hdmi_edid_upgrade_v.1.07.zip.
Bit: 32/64 Bit.
Licence: Gratuit.
Description
Corrections:
– EDID of both VGA and HDMI inputs is upgraded using this procedure
EDID upgrade procedure
1. If you are updating a VGA input on the scaler connect this input to VGA output of your PC via non-standard VGA cable as shown above (pins 5, 12 and 15 are connected, all other pins are disconnected).
2. If you are updating a DVI or HDMI input on the scaler connect this input to DVI or HDMI output of your PC a standard DVI or HDMI cable. It is possible to use DVI-HDMI adapters to connect between DVI and HDMI inputs and outputs.
3. Before upgrading HDMI input set EDID HDMI Protection in OSD of the scaler to OFF
4. Start EDID Upgrader software.
5. Click BROWSER button and browse to the appropriate PKG file.
Important Note: Pay attention to distinguish between EDID files for VGA and HDMI
6. In Step 2 select appropriate input on the scaler that you are going to update – for example VGA 1 or VGA 2 or HDMI 1 etc. For DVI ports select HDMI.
Important Note: Do not try to upgrade inputs which are not supported by this program.
7. In Step 3 select appropriate scaler that you are going to upgrade. Kramer scalers are shown under KRMx name – usually KRM0.
Important Note: Carefully verify that you select only Kramer devices. Changing by mistake EDID file of any other device (for example built-in screen of a laptop) can cause irreversible damage.
8. In Step 4 select all 3 actions – Erase, Program and Verify
9. In Step 5 click Go. Wait until upgrade process ends.
10. In Information Box check success message (Pass) for verification.
Télécharger