Intel S2600CO2 Server Board EFI Firmware 02.06.E006 Rev. 2
Type de fichier: Firmware.
Système d’exploitation: AnyOS.
Nom de fichier: R02.06.E006_Package_rev2.zip.
Bit: 32/64 Bit.
Licence: Gratuit.
Description
Versions:
– System BIOS: 02.06.E006
– ME Firmware: 02.01.07.328
– BMC Firmware: 01.28.R11044
– FRUSDR: Platform Dependent
Changements:
– BIOS: Update new IVB microcode “med306e4_0000042c.pdb”.
– BIOS: Update new SNB microcode “m6d206d6_0000061c.pdb”
– BMC: Point release to resolve Vulnerability of RC4/AES during clockwork scan
– ME Firmware: Fixed – Platform is not able to power on properly after being shut down by NM Policy
– ME Firmware: Fixed – Global platform power consumption reported by NM Statistics in S5 is incorrect
– ME Firmware: Fixed – OOB (out-of-band) stress test by issuing the wrong username may cause connection to be unavailable
– ME Firmware: Fixed – Shutdown action can be interrupted by cold reset when volatile NM policy is in use
UEFI iFlash32 Installation:
1. Boot the system to EFI Shell
2. Copy IFlash32.efi, ipmi.efi and BIOS.CAP file to a USB Flash Drive ( Do not use the Rec.CAP file as it will clear the NVRAM) Notes: It is recommended to copy full package
3. Map the respective storage device in the system with the command Shell> map -r
4. Change the Shell to mapped device file system. Example: Shell> fs0: (or fs1:)
5. Run the IFlash32 utility at the prompt fs0:> IFlash32 [File Name] /u /ni
6. Either reboot the system and Go into BIOS setup <F2>, reset defaults <F9> and save <F10> or After the BIOS update and before rebooting, run: fS0:> Iflash32 -rd
7. Reboot the system
Backup BIOS update instructions:
1. Boot the system to EFI Shell
2. Copy IFlash32.efi, ipmi.efi and BIOS .CAP file to a USB Flash Drive ( Do not use the Rec.CAP file as it will clear NVRAM). Notes: It is recommended to copy full package
3. Map the respective storage device in system with the command Shell> map -r
4. Change the Shell to mapped device file system. Example: Shell> fs0: (or fs1:)
5. Run the IFlash32 utility on the prompt fs0:> IFlash32 -u [File Name] UpdateBackupBios -ni
6. It will update primary BIOS with processed capsule, and the backup BIOS update will be completed in next normal boot.
7. Reboot the system.
Verifying updates
– Reboot the system
– During POST, hit the <F2> Key when prompted to access the BIOS Setup Utility
– Hit the F9 key to load BIOS Defaults
– At the MAIN menu verify the BIOS revision is correct
– Move cursor to the SERVER MANAGEMENT Menu
– Move cursor down to the SYSTEM INFORMATION Option and hit Enter
– Verify the BMC Firmware revision is correct
– Verify the SDR revision is correct
– Verify the ME Firmware revision is correct
– Hit the F10 Key to save changes and Exit
Télécharger