Cisco RV180 Router Firmware 1.0.5.4
Type de fichier: Firmware.
Système d’exploitation: AnyOS.
Nom de fichier: RV180-Firmware-1.0.5.4.img.
Bit: 32/64 Bit.
Licence: Gratuit.
Description
Enhancement:
– Support the free DDNS, no-ip.com.
– Enhance the daylight saving time configuration.
Issues Resolved:
– The ‘NO CONNTRACK FOUND’ message repeated in the syslog when Kernel Warning messages are enabled.
– FTP do not terminate the connection properly.
– The GUI and DHCP of RV180 becomes unresponsive after running for several days.
– In the IPv6 tunneling setting page, the Remote End Point can’t be enabled and set the remote IPv4 address.
– CoS to DSCP does not work.
– CoS to Queue with priority does not work.
– QoS scheduling by priority does not work.
– When the WAN connection type is set to PPPoE, the QoS rate limit does not work.
– QuickVPN tunnel is not established when the LAN IP subnet mask is 25 to 30 bits.
– Request to supporting the new DDNS service, no-ip.com to the RV180x platform.
– Can only manually set time to 2015 and lack the day of 29th day in February.
– Request to add the feature of daylight saving time setting.
– Unexpected to be opened pages can be opened using the PPTP connection.
– NAT between VLANs is running when PPTP server is enabled.
– Boot time is longer than the last firmware version
Procédure d’installation:
– Enregistrez le package téléchargeable.
– Connectez-vous à l’interface utilisateur Web du routeur.
– Accédez à la section de mise à niveau du micrologiciel de votre unité sans fil.
– Sélectionnez le firmware actuel et configurez votre routeur pour installer ce fichier.
– Attendez que l’appareil exécute ce processus.
– Redémarrez l’unité si nécessaire.
Télécharger