Broadsoft Snom320 IP Phone Firmware 7.3.30
Type de fichier: Firmware.
Système d’exploitation: AnyOS.
Nom de fichier: snom320-7.3.30-SIP-bf.bin.
Bit: 32/64 Bit.
Licence: Gratuit.
Description
Bugfix:
– Added new setting transfer_on_hangup_with_starcode to allow transferring calls on hangup if one call was picked up with PBX starcode. (SCPP-906)
– Clean paint area for title (snom370). (SCPP-1191)
– Codec type and TX-RX stats could not be displayed anymore during call at the display. (SCPP-1206)
– Don’t handle key event F_LOGOFF_ALL if a line is connected or on hold. (SCPP-1203)
– Don’t resend ring command if phone is already ringing even if there is more than one incomming call. (SCPP-972)
– Handle action of FKeys only if state isn’t minibrowser state. (SCPP-1217)
– Setting Use Speaker Key to Receive Calls is valid for headsetkey too now. (SCPP-1154)
– Show LDAP result instead of display name if setting prioritise_pbx_number_lookup is off. (SCPP-1215)
– Send VQ-Report for hanging up on a holding line as well. (SCPP-1213)
– Make reregister after check-sync if necessary. (SCPP-985)
– UnREGISTER sets unregistered identity to inactive. (SCPP-599)
– Termination of Registration/Subscription initiated by check-sync notify works now. (SCPP-1126)
– Some setting changes were effecting other settings even though they were not changed by the user. (SCPP-1123)
Instructions d’installation:
– Right-click on the appropriate link for your device and choose Copy shortcut:
Open the Web User Interface and navigate to the Software Update page
Paste the link into the Firmware field
(Web User Interface -> Software Update -> Firmware)
– Press Load
The Device reboots and starts the software update.
Note: Do not disconnect the power at any time during this process!
– Check your firmware version afterwards
Télécharger