Vantec NST-260WS3-WH Enclosure Firmware 1.1.68
Tipo de archivo: Firmware.
Sistema Operativo: AnyOS.
Nombre del archivo: nst-260ws3_ap_firmware1168.zip.
Bit: 32/64 Bit.
Licencia: Gratuito.
Descripción
Updating Firmware Using iOS:
– Place the *.bin file into the root path of the hard drive.
– Power off and disconnect the NST-D300WS3’s USB cable from your computer.
– Turn on the NST-D300WS3 and connect to the NST-D300WS3’s Wi-Fi signal.
– Once connected, please ensure the *.bin file is located on the root path on the hard drive.
– Click on the Settings gear icon to enter NST-D300WS3 setting and navigate to System.
– Tap on “Firmware Update” and select the *.bin file to begin. When prompted, tap Ok.
– The firmware update will proceed. Please do not turn off the NST-D300WS3 or power off your iOS device. Once the update has reached 100%, the NST-D300WS will reboot.
– You may now connect to the NST-D300WS3. Please make sure the firmware has been successfully updated by visiting the NexStar WiFi App Settings>Status.
Updating Firmware Using Android:
– Place the *.bin file into the root path of the hard drive.
– Power off and disconnect the NST-D300WS3’s USB cable from your computer.
– Turn on the NST-D300WS3 and connect to the NST-D300WS3’s Wi-Fi signal.
– Once connected, please ensure the *.bin file is located on the root path on the hard drive.
– Click on the drop down Settings icon indicated by the 3 dots to enter NST-D300WS3 setting and navigate to System.
– Tap on “Firmware Update” and select the *.bin file to begin. When prompted, tap Ok.
– The firmware update will proceed. Please do not turn off the NST-D300WS3 or power off your Android device. Once the update has reached 100%, the NST-D300WS will reboot.
– You may now connect to the NST-D300WS3. Please make sure the firmware has been successfully updated by visiting the NexStar WiFi App Settings>Status.
Updating Firmware without Software:
– Place the *.bin file into the root path of the hard drive.
– Power off and disconnect the NST-D300WS3’s USB cable from your computer.
– While holding the reset button down, turn on the NST-D300WS3.
– Continue to hold for 10 seconds and let go of the reset button.
– The hard drive LED indicator will blink and flash indicating Firmware update is in progress, please allow at least 2 minutes for the process to complete.
– Power cycle the NST-D300WS3 allowing at least 4 seconds of power off.
– You may now connect to the NST-D300WS3. Please make sure the firmware has been successfully updated by visiting the NexStar WiFi App Settings>Status.
Descargar