Ubiquiti R5AC-PTP System Firmware 8.4.0.35708
Tipo de archivo: Firmware.
Sistema Operativo: AnyOS.
Nombre del archivo: XC.v8.4.0.35708.170929.1512.bin.
Bit: 32/64 Bit.
Licencia: Gratuito.
Descripción
Important:
– Maximum supported CPE/Station count limited to 60 while in GPS Sync mode
Nuevo:
– New: TDD Framing/GPS Sync support for 20/40MHz in AP PtMP airMAX Mixed mode (XW, v6.1.0 required)
– New: Enable/disable AMSDU aggregation in Wireless Advanced section
– New: VRRP IPv6 passthrough
– New: Antenna selection list for PrismStation 5AC and IsoStation 5AC
– New: Upgrade miniupnpd to v2.0
Mejoras:
– Improved long range PTP mode
– Improved scan for non-DFS frequencies (active scan)
– Improvements to VoIP performance
– AirOS stability improvements
– AirOS security improvements
Correcciones:
– Fix: VRRP passthrough
– Fix: ATPC issue on SISO devices
– Fix: Latency spikes when Station disconnects
– Fix: RX Capacity drop on Station in PTMP mode after scan
– Fix: Site Survey doesn’t show all available APs after scan
– Fix: airMagic is not working in some cases when devices are misconfigured
– Fix: Station doesn’t connect back to AP with the strongest RSSI in case of several APs with the same SSID
– Fix: Sometimes home routers fail to renew DHCP lease (fixed regression in dnsmasq v2.66)
– Fix: Reduced HW Watchdog resets (possible fix)
WEB UI:
– WEB UI: Device model reporting on Dashboard header
– WEB UI: Show warning in airMagic if airView is disabled
– WEB UI: Show warning in Speed Test if Destination IP is the same as device IP in Speed Test
– WEB UI: Show ambient noise and corresponding frequency on mouse hover in Dashboard on airView bar
– WEB UI: Improve Rate and Burst values parsing and validation in Traffic Shaper Rule
– WEB UI: LAN Speed, Cable SNR & Length reporting for 2nd Ethernet port for local & remote devices on Dashboard
– WEB UI: Disable Signal, Noise & Interference charts if remote station doesn’t provide required data
– WEB UI: Hide airView enable/disable option if device doesn’t have airView radio
– WEB UI: Don’t allow extensions (i.e., LastPass) to fill in configuration fields
– WEB UI: Impossible to Clear or Refresh System log on mobile phones
– WEB UI: airMagic doesn’t show full frequency range
– WEB UI: Reconnect button visibility issue
Descargar