Intel R1304RPOSHBN Server System EFI Firmware 03.03.0006
Tipo de archivo: Firmware.
Sistema Operativo: AnyOS.
Nombre del archivo: S1200RPL_S1200RPO_S1200RPM_EFI_BIOS03030006_BMC118_FRUSDR108.zip.
Bit: 32/64 Bit.
Licencia: Gratuito.
Descripción
Versiones:
– BIOS: R03.03.0006
– ME: R03.00.07.024
– BMC: 01.18.9983
– FRUSDR: 1.08
BIOS Changes in R03.03.0006:
– NOTICE: Capsule update method: If previous BIOS version is R02.02.0004 and earlier version, need use E3-1200 V3 CPU part boot to EFI shell, and use capsule files update BIOS to R03.03.0006 and update ME to 3.0.7.24,then replace with E3-1200 V4 CPU part to power on.
– EPSD100254574: SUT power on failed after shut down from OS.
ME Changes in 03.00.07.024:
– Fixed: Platform does not go to S3/S4 state in recovery mode
– Fixed: Wrong value returned from Get Max Allowed Logical Processors command after S0->(S4,S3)->S0 transition
BMC Changes in 01.18.9983:
– Fixed: Cannot set «Alert Destination IPV6 Address» use «syscfg /lacipv6 1 1 1111:2222:3333:4444:5555:6666:7777:8888 Enable 1 10» where «Alert Destination Index is not ‘0
FRUSDR Changes in release 1.08
– Fixed: The sensor reading of P1 MTT is always 0 in EWS(Intel Integrated BMC Web Console)
UEFI iFlash32 Installation:
1. Boot the system to EFI Shell
2. Copy IFlash32.efi, ipmi.efi and BIOS.CAP file to a USB Flash Drive ( Do not use the *Rec.CAP file as it will clear the NVRAM) Notes: It is recommended to copy full package
3. Map the respective storage device in the system with the command Shell> map -r
4. Change the Shell to mapped device file system. Example: Shell> fs0: (or fs1:)
5. Run the IFlash32 utility at the prompt fs0:> IFlash32 [File Name] /u /ni
6. Either reboot the system and Go into BIOS setup <F2>, reset defaults <F9> and save <F10> or After the BIOS update and before rebooting, run: fS0:> Iflash32 -rd
7. Reboot the system
Backup BIOS update instructions:
1. Boot the system to EFI Shell
2. Copy IFlash32.efi, ipmi.efi and BIOS .CAP file to a USB Flash Drive ( Do not use the Rec.CAP file as it will clear NVRAM). Notes: It is recommended to copy full package
3. Map the respective storage device in system with the command Shell> map -r
4. Change the Shell to mapped device file system. Example: Shell> fs0: (or fs1:)
5. Run the IFlash32 utility on the prompt fs0:> IFlash32 -u [File Name] UpdateBackupBios -ni
6. It will update primary BIOS with processed capsule, and the backup BIOS update will be completed in next normal boot.
7. Reboot the system.
Descargar