D-Link DAP-2310 rev.A Access Point Firmware 1.16
Tipo de archivo: Firmware.
Sistema Operativo: AnyOS.
Nombre del archivo: DAP-2310 _fw_revA1_1-16_all_multi_20140108.zip.
Bit: 32/64 Bit.
Licencia: Gratuito.
Descripción
Cambios:
1. The setting key will be saved as encryption characters
2. encrypt some sensitive info of WEB & SNMP
3. Fix in open system can be save success without network key
4. Fix in Repeater mode when SSID Visibility disabled ,Repeater can’t connect to the root AP
5. Fix in APC mode when SSID Visibility disabled ,APC can’t connect to the root AP
6. Fix in MultiSSID setting when only change the WEP Key Index, will pop up the warning message
7. Fix “Periodical Key Change” function doesn’t work
8. Fix “MAC Clone Manual” function doesn’t work
9. Fix “MultiSSID+WEP Spec Character” STA can’t be connect to
10. Fix security can’t be sync in AP Array
11. Fix in WPA-PSK 64 hex doesn’t work normally
12. Fix in “Limit Administrator IP” for set IP in CLI and WEB
13. Fix in “MultiSSID’s Priority” function doesn’t work
14. Fix WPA Authentication cannot work
15. Fix WDS connect issue
16. Fix in WDS->WPA-Personal security can’t be scan
17. Fix in VLAN -> Disable the Multi-SSID but VLAN auto disable
18. Fix when set authentication to WPA-PSK and select autokey then use station to connect, it will show none.
19. Fix password support ASCII when the length less than 64
20. Add MIB for “clientinfo tx rx byte”
Procedimiento de instalación:
– Guarde el paquete descargable.
– Inicie sesión en la interfaz de usuario web del enrutador.
– Navegue a la sección de actualización de firmware de su unidad inalámbrica.
– Seleccione el firmware actual y configure su enrutador para instalar este archivo.
– Espere a que el dispositivo realice este proceso.
– Reinicie la unidad si es necesario.
Descargar