Sony Alpha DSLR-A700K Camera Firmware 1.10
Dateityp: Firmware.
Betriebssystem: Windows 10, Windows 7, Windows 8, Windows 8.1.
Dateiname: DSCA700v04.exe.
Bit: 64 Bit.
Lizenz: Kostenlos.
Beschreibung
This utility updates the DSLR-A700 Camera Firmware to version 4 and provides the following benefits:
Benefits over firmware version 3:
– Adds a “2 steps/3 shots” option to the “Bracket: Single” and “Bracket: Cont.” Drive mode settings for auto exposure bracketing.
– Adds an “Off” option to the “High ISO NR” (Noise Reduction) setting.
– Provides improvements in picture quality when using a high ISO setting; color noise is minimized in images captured using an ISO setting of 1600 or higher.
– Provides improvements to the Auto White Balance (WB), especially when taking pictures using the flash.
– Improves performance of the D-range Optimizer (DRO). The ability to discriminate between scenes has been improved, and the scope to which the advanced DRO effect can be applied has been broadened.
– Improves the ability to make a successful connection with the VG-C70AM vertical grip.
Additional benefits over earlier firmware versions:
– Resolves an issue where the Access Lamp remains lit and the camera stops responding when several pictures are taken in rapid succession.
– Resolves an issue where powering the camera off while in “MR” mode may cause some registered settings to carry over to other shooting modes.
– Sharper images for pictures taken under low contrast conditions
– Reduced noise for pictures taken at ISO 3200
– Improved flash control for objects closer than 1 meter with non ADI controlled lenses
Update the Firmware
WARNING!!: When performing the firmware update, use a fully charged rechargeable battery pack NP-FM500H or the AC adapter AC-VQ900AM AC adapter/charger (sold separately). Do not remove the battery or AC adapter during the firmware updating, otherwise the camera may be permanently damaged.
– Slide the POWER switch to the ON position and set the “Memory card” to the type you are using for the update (Memory Stick Duo / CF card / Microdrive) in Setup Menu 2 , then slide the POWER switch to the OFF position.
– If it is not already there, insert the formatted recording media (Memory Stick Duo / CF card / Microdrive) into the camera
– Press and hold the MENU button. While holding the MENU button, slide the POWER switch to the ON position. Continue to press the MENU button until the confirmation window appears.
– The confirmation window appears.
– Use the Multi-selector to highlight “OK”, then press the Center button of the Multi-selector. The Updating procedure will start.
– When the “Update is completed” message appears, the updating procedure is complete.
Note: The camera automatically restarts after about 5 seconds.
– Power off the camera, then remove the recording media.
Download