Point Grey Dragonfly Express Camera Firmware 1.1.1.21
Dateityp: Firmware.
Betriebssystem: AnyOS.
Dateiname: dragonfly-express-ver1.1.1-21.zip.
Bit: 32/64 Bit.
Lizenz: Kostenlos.
Beschreibung
Fixes:
Enhancements:
– 19394 – Initial firmware release for camera
Firmware update:
[1] Bug 3214: After power cycle, first frames grabbed are corrupted
– image transmission now delayed for 250ms after power-up except in async trigger modes
[2] Bug 4159: Config ROM model textual descriptor change to „Dragonfly Express DX-BW“ and „Dragonfly Express DX-COL“
[3] Bug 3460: First exposed image sometimes thrown away and not streamed to PC
– always throw away the first exposed image acquired when exiting async trigger mode
[4] Bug 3500: Toggling between trigger modes 0 and 14 cause image to be streamed
[5] Bug 3886: Images streamed when iso disabled / trigger enabled
[6] Bug 3709: Power failure results in transmit failure when starting camera in Format_7
[7] Bug 4238: Frame buffer state machine freeze-up
[8] Bug 3440: Embedded image info may not apply to current image
– shutter, gain, brightness, and white-balance should almost always be correct.
– GPIO state and strobe pattern counter are still incorrect.
– shutter value transmitted does not have any of the control bits set (ie: only reports Presence and Value)
[9] Bug 3658: Strobe control not showing as present when pin configured as input
– Strobe control reported as present for all pins capable of strobe
– On_Off_Inq bit of the Strobe_X_Inq register set to zero when the associated pin is currently set as an input.
[10] Format_7 now picks most pessimistic nominal frame rate (rate is achievable regardless of ROI position)
Download