Intel H2312JFJR Server System OFU Firmware 02.05.0004
Dateityp: Firmware.
Betriebssystem: AnyOS.
Dateiname: S2600JF_SFUP_BIOS02050004_ME020107328_BMC123r7783_FRUSDR113.zip.
Bit: 32/64 Bit.
Lizenz: Kostenlos.
Beschreibung
Versionen:
– BIOS: 02.05.0004
– ME: 02.01.07.328
– BMC: 01.23.7783
– FRUSDR: 1.13
BIOS R02.04.0003 Changes:
NOTICE: As security requirement, R02.05.0004 revision doesn’t support capsule downgrade in normal mode. In order to downgrade from this BIOS version, you must use the recovery jumper method.
-This version enhances the protection of platform configuration data as described in Intel Security Advisory INTEL-SA-00043
– Updated: RSTe OPROM to 4.2.0.1036
– Fixed: BIOS is configuring PCI configuration space Device control register 08 on one of the downstream port of PLX and the two 10GB NIC endpoints to 256B instead of 128 .
– Fixed: Sysinfo_v13.1.4: BIOS information “system information” cannot be dump into sysinfo_log.txt.
– Fixed: AXX10GBNIAIOM intermittently can not be detected on HNS2600WP after rebooting when installing two to four nodes in chassis.
– Fixed: “ID_NET_NAME_ONBOARD=eno1” are same for two onboard NICs which should be different.
– Fixed: EFI Boot Options issue in BIOS
– Fixed: Syscfg v12 build 14: BootOrder will be changed before and after running cmd: syscfg /s file.ini /f /b
– Fixed: Boot order will not be load default by F9 but could load default by ‘Syscfg /bldfs’.
– Fixed: No Usable Memory Found after 240V AC line exponential dropout test Variable.
– Fixed: R02.05.0001 OFU/iflash32 hang.
– Fixed: Sysinfo_v13.1.4: BIOS option “Processor PCIe Linkd Speed<socket1 and socket2>” cannot be dump into sysinfo_log.txt.
– Fixed: [x]BIOS configuration re-initialization issue after cold boots.
ME 2.01.07.328 Changes:
– Fixed: Platform is not able to power on properly after being shut down by NM Policy
– Fixed: Global platform power consumption reported by NM Statistics in S5 is incorrect
– Fixed: OOB (out-of-band) stress test by issuing the wrong username may cause connection to be unavailable
– Fixed: Shutdown action can be interrupted by cold reset when volatile NM policy is in use
BMC 01.23.7783 Changes:
– Fixed: IPMB Bridging commands to a Satellite controller doesn’t work
– Fixed: The result of IPMI raw command 20 c0 71 00 02 00 00 shows telnet can be supported.
– Fixed: The satellite FW updating status is 00 while updating HSBP FW.
– Fixed: i2c-adapter i2c-7: Arbitration lost on data transmission
– Fixed: Remote KVM video have some dirty mouse cursor under linux system
– Fixed: The System Fan 5 spinning in 100% speed on S2400BB Platform after updated the BMC to 1.21.6038.
– Fixed: FW update will fail with OS based utility (OFU), failure rate is 20% with USB mode and 40% with KCS mode.
– Fixed: BMC code issue for fan detection on S2600CO.
– Fixed: EWS can’t interpret SmaRT/CLST event
– Fixed: S2600GZ/GL EWS_update tool fail with SUP S2600GZ_GL_EFI_BIOS02030003_ME20107328_BMC1216038_FRUSDR113
– Fixed: Openssl update (see TA-1065)
– Fixed: IPv6 can’t get IP address via DHCP server.
– Fixed: S4600LH P3 LVDIMM voltage reading is 1.5V sometimes during system booting up
– Fixed: HSC firmware not updating with BMC 1.21.6038;
– Fixed: BMC Hangs upon the first A/C Power On of the board. Subsequent A/C power cycles, the BMC boots.
– Bundled the new PSU fw for PSSF162202A.
– Bundled the new PSU fw for “DPS 750AB 32A”.
– Set RMM4 DMN speed to 100Mbps on half width products
Download