Buffalo WHR-600D Router Firmware 2.50
Dateityp: Firmware.
Betriebssystem: AnyOS.
Dateiname: WHR-600D_FW2.50.zip.
Bit: 32/64 Bit.
Lizenz: Kostenlos.
Beschreibung
Bug Fixed:
– Fixed the issue where the permit configuration for „Internet-side Remote Access“ didn’t function correctly.
– Fixed the issue where the AirStation obtained an IP address automatically from the DHCP server even though an IP address was configured to be fixed if the AirStation was rebooted in bridge mode.
– Fixed the issue where the error message, „Invalid firmware.“ appeared and the AirStation rebooted when [Update Firmware] is clicked without choosing the firmware file on the „Update Firmware“ page.
– Fixed the issue where the AirStation didn’t refer to the secondary DNS server even though it received error packets from the DNS server.
– Fixed the issue where the AirStaion in wireless bridge mode could not access the master device even though the WPS button on the Setting was pushed.
– Fixed the issue where it took an excessively long time to load Settings.
– Fixed the issue where the connection destinations of PPPoE didn’t display correctly on Settings.
– Fixed the issue where some multicast packets were not transferred when snooping was enabled.
– Fixed the issue where the AirStation could not access to the internet even though the PPPoE status is „Online“ on the Settings.
– Fixed the issue where the PPPoE settings could not be configured properly.
How to update the firmware:
– Connect the AirStation to the same network as your PC. For best results, connect the AirStation directly to your PC with an Ethernet cable.
– Boot your PC.
– Confirm that the PC’s and the AirStation’s IP addresses are on the same network subnet. Refer to AirStation’s user manual to confirm how to change IP address settings.
– Open a browser and enter „192.168.11.1“ in the URL field, then press the enter key.
– Enter „admin“ for the username and „password“ for the password. Note: If you changed the password, enter the password that you configured.
– Click „Update AirStation Firmware“ at the left of the screen.
– Click „Browse“ to the right of „Firmware File“ and navigate to the firmware file.
– When the update starts, the power LED will blink red. It will take about 6 minutes to finish updating. When it finishes, the power LED will blink green or turn off. Do not disconnect power to the unit while the power LED is blinking red or your AirStation may be damaged.
– To confirm that your firmware is successfully updated, check the version number.
Download