Atomos Ninja V Recorder Firmware 10.4
Dateityp: Firmware.
Betriebssystem: AnyOS.
Dateiname: ATOMNJV_10.4.zip.
Bit: 32/64 Bit.
Lizenz: Kostenlos.
Beschreibung
Unterstützung für the AtomX SYNC module
– AtomOS 10.4 adds support for the AtomX SYNC module to allow the creation of a wireless RF and Bluetooth network for the synchronization of timecode.
– Connect and remote trigger up to 100 Ninja Vs with AtomX SYNC modules, or GoPros compatible with the Timecode Systems SyncBac Pro product.
– Synchronize timecode with any number of Timecode Systems existing devices at distances on wireless RF up to 200m. Out of range mode allows all devices to default to their internal TCXO to maintain accurate timecode and when back in range will soft sync with the master device once again.
– Pair up to 6 Bluetooth devices, via compatible apps and hardware, up to 15m or extend Bluetooth range with the Ultrasync Blue.
– Jam sync the Ninja V to any existing Timecode source by connecting the input to UltraSync One or add any device with LTC/Genlock/Wordclock to the Ninja V SYNC network by connecting to the UltraSync One
– Auto Calibrate accurate audio offset between HDMI and analogue audio inputs to the Ninja V
– Add Continuous power to allow the hot swap of batteries on the Ninja V
17:9 DCI Letter Box Display
– HDMI inputs with a 4096×2160 resolution are displayed in a 17:9 aspect ratio with top and bottom black letter box
Firmware Update Tutorial:
– Download and unzip the file.
– Copy the file onto a recommended, formatted driver, using the docking station included with your recorder.
– Insert the drive into the Atomos recorder while it’s off.
– Power up the Atomos recorder.
– The screen will show flashing lines of color. This is normal – DO NOT power off!
– Updating will take a few minutes.
– Once completed, the Atomos recorder will power down.
– Power up the Atomos recorder again.
– Check Menu > Product Info > AtomOS Version. This should match the version you have just downloaded.
– Enjoy your updated Atomos recorder !
Firmware Recovery Tutorial:
– Power down the Atomos recorder (Hold power button for 4 seconds).
– Hold down the power button for 10 seconds approximately.
– You will see the “Firmware Update Failed” screen.
– Insert your HDD / SSD.
– The install process will begin and the screen will show flashing lines of color. This is normal – DO NOT power off !
– Once completed, the Atomos recorder will power down.
– Enjoy your updated Atomos recorder !
Download