Fractal Audio Axe-Fx II XL Preamplifier Quantum Firmware 1.00
Tipo de arquivo: Firmware.
Sistema operacional: AnyOS.
Nome do arquivo: axefx2_xl_Quantum_1p00.zip.
Bit: 32/64 Bit.
Licença: Grátis.
Descrição
Quantum represents a milestone in amplifier modeling technology. Our new Real-Time Spice (RTS) algorithms offer a degree of accuracy not found in any other product. Below are the significant changes/additions from the previous non-Quantum firmware.
Added “Dephase” control to Cabinet block:
– This parameter controls a sophisticated process that removes the “phasiness” from IRs and can yield a more “in the room” experience.
– Note that the processing required is extreme and the control can have some lag.
– No extra CPU usage or audio latency, however, is incurred.
New RTS triode models:
– There are three new triode models based on our new algorithms: 12AX7A (default), ECC83 and 7025.
– The previous models are still available and may be selected with the Pre Tube Type parameter.
– Note that the models have all shifted and if you were using a model other than default previously you will need to adjust your preset to the desired model.
Added new Preamp Compressor Type “Comp Type” parameter to amp block:
– There is a new menu page that contains Preamp Comp, Comp Type, Dynamics, Preamp Bias and Output Level (the last repeated from other menus for convenience).
– Preamp Comp Type selects between “Authentic”, which accurately models the compression in a tube amp, and “Ideal” which is an idealized distorting compressor.
– The idealized type is more focused and has tighter bass whereas the authentic type is bolder and looser.
– High gain players may prefer the ideal type due to its tight character.
Added a new mode to the “Character” controls in the Amp block:
– A Char Type of “Dynamic” engages an exciting new mode of tone control.
– This can be used to fatten or scoop the tone as a function of picking strength.
– For example, set the Type to Dynamic, Char Freq to 450.0, Char Q to 0.7 and Char Amt to 4.0.
– This will cause the tone to get fatter and thicker as you play hard but without getting honky when playing soft.
Added four “JMPre-1” models based on a Marshall JMP-1 rack preamp:
– The existing “Brit Pre” model was not changed as it is used by several prominent “A-list” artists.
– Instead, four new models were added.
– The models with “BS” in the name indicate that the Bass Shift function is engaged.
– Note that the model defaults to the power amp simulation active.
– The power amp model is based on a typical Marshall 100W power amp of that era.
Fixed Dry Delay Shift parameter not working in Flanger block:
– The parameter has been renamed to Dry Delay and works differently (and more intuitively).
– The parameter now sets the delay time of the dry signal as a percentage of the maximum delay time of the wet signal.
– For classic thru-zero flanging this parameter should be set to 50%.
– For interesting new sounds experiment with lower or higher values.
– Note that this parameter has no effect if Through Zero is set to Off.
Other Changes:
– Fixed smallest LCD font having a smiley face for left bracket character.
– The “CF Comp” parameter has been renamed “Preamp Comp” to better explain its function.
– Added 512 more User Cab slots to XL and XL+ models.
– Added 20 new Cabinet models (XL and XL+ versions only) from our Universal Noise Studios 4×12 cabinet pack. These IRs are specifically intended to be used in mixes “in the box”. Mix two IRs from each cab for a myriad of sonic textures.
Download