Kramer VP-730 Presentation Scaler-Switcher Oprogramowanie 1.15 Master
Typ pliku: Oprogramowanie.
System Operacyjny: AnyOS.
Nazwa pliku: vp-730_731_fw_1.15.zip.
Bit: 32/64 Bit.
Licencja: Darmowa.
Opis
The following changes were made in this version:
Poprawki:
– A problem of occasional HDMI output video noise appearing on some monitors was fixed.
Known Issue:
– There may be an increased delay (in extreme cases, up to 20 seconds) after switching to an HDMI input connected to a Blu-Ray player.
Technical Notes:
– An HDMI noise problem was fixed.
– This change also requires hardware changes that can only be implemented in the Kramer manufacturing facility.
– The new master firmware version 1.15 can also be used without the hardware change. In this case it works identically to the previous version 1.14.
Firmware Upgrade Procedure
1. Acquire xxx.brec file with the required version of firmware.
2. Copy this file to the route directory on any USB readable memory device (disk-on-key, flash memory card etc.).
3. Plug the device with the firmware file into USB connector of the VP728/729 and switch on the scaler.
4. Wait until the scaler boots up and then use OSD menu to navigate to Setup>Advanced Setup>Misc>Firmware Download
5. Use UP and DOWN arrows to highlight the required firmware file and press ENTER button.
6. Confirm the upgrade and wait until progress indicator gets to 100%.
7. Restart the scaler by recycling the power.
Pobierz